User manual INTERQUARTZ C380

[. . . ] s Issued by Gigaset Communications GmbH Schlavenhorst 66, D-46395 Bocholt Gigaset Communications GmbH is a trademark licensee of Siemens AG Gigaset Communications GmbH 2008 All rights reserved. www. gigaset. com Gigaset C380 Gigaset The handset at a glance The handset at a glance 16 V 07:15 Menu 1 2 15 14 13 12 11 01. 10. 08 3 4 5 10 9 8 6 7 The base station at a glance 1 Display in idle status (example) 2 Charge status of the batteries( page 10) 3 Display keys ( page 16) 4 Message key ( page 26) Access to calls and message lists; Flashes: new message or new call 5 End call key, On/Off key End call, cancel function, go back one menu level (press briefly), back to idle status (press and hold), activate/deactivate handset (press and hold in idle status) 6 Hash key Keypad lock on/off (press and hold in idle status); toggle between upper/lower case and digits 7 Internal key Make an internal call ( page 37) 8 Microphone 9 Recall key ( page 43) - Recall (flash) - Insert a dialling pause (press and hold) 10 Star key Ringer tones on/off (press and hold), With an existing connection: Switch between dial pulsing/touch tone dialling (press briefly) 11 Key 1 ( page 34) Dial network mailbox (press and hold) 12 Connection socket for headset( page 14) 13 Talk key Answer a call, open last number redial list (press briefly), start dialling (press and hold) When writing an SMS: send SMS 14 Handsfree key Switch between earpiece and handsfree mode; Lights up: handsfree activated Flashes: incoming call 15 Control key ( page 16) 16 (Signal strength ( page 10) Registration/ Paging key ( page 37) 1 Contents Contents The handset at a glance . 6 Setting up the base station and charging cradle (if included) . 7 Connecting the charging cradle (if included) . [. . . ] Menu SMS Settings Service Centres q Select an SMS centre (e. g. You have the following options: Active Send Srvc. If the SMS messages are to be sent through this SMS centre, press OK to activate the SMS centre ( = on). If a different SMS centre was active previously, then this will be deactivated. For the SMS centres 2 and 3, the setting only applies to the next SMS. SMS Centre No Enter the number of the SMS centre and press OK. You should find out about the services Activating/deactivating SMS function The SMS function is active by default. If you deactivate the SMS function, you cannot send or receive any SMS messages with your phone. The settings you have made for sending and receiving SMS messages (e. g. the numbers of the SMS centres) and the entries in the incoming and draft message lists are saved even after you turn off your phone. Q OK Or: OK Activate SMS function. Sending an SMS via another SMS centre active send service centre ( page 32). This setting only applies to the next SMS to be sent. After that, the setting returns to SMS Centre No 1. Activate the SMS centre (2 or 3) as the 32 SMS (text messages) SMS troubleshooting Error codes when sending E0 Calling Line Identification permanently withheld (CLIR) or Calling Line Identification not activated. FD Connection to SMS centre failed; see selfhelp. The SMS is played back. The "display call number" service is not activated. Ask your service provider to enable this feature (there is a charge for this). 2. Your mobile phone operator and your fixed line network SMS service provider have not agreed on a co-operation. Obtain information from your fixed line network SMS service provider. Your end device has been recorded by your SMS provider as having no fixed line network SMS functionality, i. e. you are no longer registered with the provider. Start the registration assistant for automatic registration ( page 29). Have the device (re-)registered to receive SMS messages. Self-help with errors The following table lists error situations and possible causes and provides notes on troubleshooting. You cannot send messages. You have not requested the CLIP service (Calling Line Identification Presentation). [. . . ] u Characters are inserted to the left of the cursor. u The first letter of the name of directory entries is automatically capitalised, followed by lower case letters. Press the hash key # briefly to switch from "Abc" mode to "123" and from "123" to "abc" and from "abc" to "Abc" (upper case: 1st letter upper case, all others lower case). Press the hash key # before entering the letter. You can see briefly in the display whether upper case, lower case or digits is selected. Writing an SMS/names Press the relevant key several times to enter letters/characters. Standard characters 2a b c 2 3d e f 3 4g h i 4 5j k l 5 1x 2x 3x 4x 5x 6x 7x 8x 9x 10x 11x 12x 13x 14x 1) 2) 1$ Lm n o 6 Mp q r s 7 Nt u v 8 Ow x y z 9 Q. [. . . ]