User manual IOGEAR GBHFK231 INSTALLATION GUIDE

[. . . ] Plug the micro-USB connection end of the USB charging cable to the Solar Power Bluetooth Car Kit, and the other USB Type A connector end to the USB Type A female port of the included car charger. Plug the car charger completely into the cigarette lighter in your car and turn on the power of your car. The LED light on the Car Kit will light up during charging, and it will turn off when charge completes. It will take approximately up to 3 hours to get a full charge thru the car charger. 8 9 Using solar power 1. [. . . ] Enter "0000" and press OK to establish the connection. 16 Note: If the pairing process can not be completed within 2 minutes after pairing mode is activated, the Car Kit will power off automatically. Please repeat above steps again to pair your Bluetooth enabled cellular phone and the Car Kit. 17 Operating the Car Kit with Two Bluetooth enabled phones Activate multi-point connection 1. The default setting of Car Kit's multi-point connection is off. To turn this on, power on the Car Kit and make sure it is in standby mode. Then press and hold "+" button for 3 seconds until hearing a beeping sound. To turn off this feature, under standby mode, press and hold "-" for 3 seconds until hearing a beeping sound and the Car Kit will power off automatically. When power on the Car Kit again, it will only connect to the last connected Bluetooth enabled cellular phone. Note: When the multi-point feature is in use, the Car Kit does not support three-way calling feature. 18 Pair Two Bluetooth enabled cellular phones 1. Before begin to pair two Bluetooth enabled phones with the Car Kit, first you need to make sure to activate the multi-point feature. Please refer to page 18 for instructions. Complete the pairing process with first phone following the steps in page 16. Press and hold the MFB button for 6 seconds to enter pairing mode again to pair and connect with the second phone following steps in page 16. When the pairing is completed with the second phone, the Car Kit will automatically connect to the first phone. 19 Note: If the Car Kit does not connect back to the first phone or having problem staying connected with any one of the two phones, try to power cycle the Car Kit and it should reconnect back to the two phones. Answering call from the second phone during a call on the first phone When a new call comes in on the second phone, quick tab the MFB button twice to hold the call on the first phone and pick up the call from the second phone. Quick tab the MFB button twice again to switch from the call on the second phone back to the call on the first phone. 20 Rejecting call from the second phone When a new call comes in on the second phone, press and hold MFB button for 3 seconds to reject the call from the second phone. Switch between two calls on two phones Quick tab the MFB button twice to switch between the calls on two phones. When on an active call, short press MFB button to end the call and stay with the other call. 21 Using your Car Kit Power On Long press the MFB button for 4 seconds until you hear a short beep. The BLUE LED will flash 5 times and the Car Kit will automatically connect to the last connected phone. Long press the MFB button for 4 seconds until you hear a short beep. The RED LED will flash 5 times before powering off. Short press the MFB button to answer the call. [. . . ] - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. 30 THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. this device may not cause interference and 2. [. . . ]