User manual IOGEAR GPEN300 QUICK START GUIDE FOR MAC

[. . . ] Each channel has its own Serial ATA bus and will support one Serial ATA device. The board supports Serial ATA Generation 1 transfer rates of 1. 5 Gb/s (150 MB/s). 5 Features PCI Interface · Compliant with PCI Specifications, Revision 2. 2. · 32 bit, 33/66MHz fully compliant PCI host interface. High Speed Serial ATA Interface · Four high speed Serial ATA interface ports, each supporting 1st generation Serial ATA data rates (1. 5Gb/s). [. . . ] The required capacity decreases as the number of disks in the group increases. 9 Just a Bunch of Disks (JBOD/Contiguous) JBOD (also known as Contiguous) means a logical drive that can either be an entire disk drive or a segment of a single disk drive. For this card, the JBOD function only supports one disk. JBOD here is a Contiguous configuration option when using the "Create RAID Group" within the SATARAID5 Manager Utility. 10 Installation Procedure 1. Insert the Host card into an available bus slot. Remove all existing SATARAID GUIs (or Java SATARAID GUIs) to ensure your new SATARAID5 GUI installs and functions properly. Power down the computer system once again. Connect Hard Drives to the proper SATA Ports. Power on the computer system once again. If you connect any used HDDs to the SATA Ports, Press CTRL+S or F4 and delete any RAID settings that may be on the drives when using the BIOS boot method. 11 11. Use the SATARAID5 Manager GUI to configure your RAID settings. If using 1 Disk, please select "Concatenate" or "Contiguous" settings only. Your RAID hardware configuration is complete. Proceed to software installation section. As the BIOS boots, Press CTRL+S or F4 to enter the RAID bios utility. As the BIOS boots, Press CTRL+S or F4 to enter the RAID bios utility. As the BIOS boots, Press CTRL+S or F4 to enter the RAID bios utility. As the BIOS boots, Press CTRL+S or F4 to enter the RAID bios utility. If the RAID set being deleted is a Striped, then all of the data will be lost. If the set being deleted is a Mirrored set, then the data will remain intact and accessible on both drive sets. After replacing the failed hard drives boot the BIOS, Press CTRL+S or F4 to enter the RAID bios utility. Answer Y to rebuild the Mirrored set of hard drive. 17 Software Installation Windows XP Fresh Installation 1. Insert the controller card into a PCI slot and connect the hard drives to the controller card. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. [. . . ]