Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual IOMEGA 2CLIKTRO. We hope that this IOMEGA 2CLIKTRO user guide will be useful to you.
Lastmanuals help download the user guide IOMEGA 2CLIKTRO.
Detailed instructions for use are in the User's Guide.
[. . . ] Parallel Port Interface, verify that the printer's power is ON; then restart your computer. Desktop Dock is receiving electrical power. (See the Desktop PC Computer Setup--steps 1 through 9--on your Quick Start Card. ) If you don't think the Clik!Desktop Dock is receiving electrical power, complete the following steps: Disconnect the Clik! [. . . ] Mobile Drive will not function properly if you cancel this procedure without finishing. If you did cancel the driver search, remove the Clik!If a prompt is received to have Windows® search for a driver, follow the steps above. If the prompt it not received, follow the instructions below: a. Right click on My Computer and select Properties. Expand the Hard Disk Controllers section, and remove the PCMCIA adapter. This adapter may also be labeled as PCMCIA ATA Controller or something similar. (Do not remove anything from the PCMCIA Sockets section. ) b. Parallel Port Interface" is present with a yellow exclamation point on top of the SCSI icon, highlight it and click Remove. If your system locks up when you remove the Clik!PC Card Adapter, be sure to follow the Clik!PC Card Adapter removal instructions on page 27 of the Clik!TM Drive User's Manual.
d. Reboot the system and let Windows® search for the updated driver as outlined above. Uninstall any versions of the CardWorksTM software. PC Card Adapter is not compatible with CardWorks. Check for available IRQs (Interrupt Request). Right click on My Computer and select Properties. Select Devices by Type, make sure the Computer icon is highlighted, and click on the Properties button. Click on the Device Manager tab.
I am unable to print.
1. Review the "Printer Troubleshooting for Windows® 95/98" section on page 45 of the Clik!TM Drive User's Manual. If you have a printer connected to the parallel port of your notebook, and cannot print, remove the Clik!(Follow the previously givien instructions under "My System locks up . [. . . ] If you have already done so, replace the drive in the Clik!Desktop Dock; your system should return to normal.
TM
I'm unable to perform a long format of a Clik!TM disk on my Windows CE® device.
The Sleep Mode default setting on most Windows CE® devices turns on after five minutes of nonuse. During a full format, large capacity media (like a Clik!disk) would not be completely formatted before the CE device goes into Sleep Mode. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE IOMEGA 2CLIKTRO
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual IOMEGA 2CLIKTRO will begin.
