User manual IOMEGA DESKTOP HARD DRIVE QUICK GUIDE

[. . . ] Make sure you are using the USB or FireWire cable that came with your drive. Make sure the drive is connected to only one interface (USB or FireWire). Do not plug the drive's data cable into a hub or keyboard. pC Users: · If you are using a USB 2. [. . . ] pC Users: · If you are using a USB 2. 0 host adapter, make sure that the correct drivers for the adapter have been installed and the operating system recognizes it. If you are using a version of Mac OS X below 10. 3, format the drive HFS+ or partition the drive into smaller volumes (less than 127GB). use Disk Utility to partition and format the drive. If the drive is still not assigned a drive letter, please visit the Support & Downloads area on www. If your PC will not start up when the drive is connected, there is probably a conflict with the computer. To work around this problem, power off the drive when starting the computer. Power on the drive after the computer finishes starting up. Complete User's Manual A complete user's manual in HTML format is available on the Support & Downloads area on www. If your product is eligible for warranty service, you will be required to return it to Iomega, along with proper identification, a return authorization number obtained from the Iomega website or provided by the Iomega representative, and proof of purchase. Iomega will not protect, recover, or return data during warranty service so you should duplicate your data before shipment. Any implied warranty required by applicable law shall be limited in duration to the express warranty term. Some jurisdictions do not allow disclaimers of implied warranties or limitations on how long an implied warranty lasts, so the above limitation may not apply to you. This warranty gives you specific legal rights and you may also have other rights that vary from jurisdiction to jurisdiction. Any suit for breach of any warranty on your Product must be filed within one (1) year of the first date the suit could have been brought. This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]