User manual IOMEGA ULTRAMAX PLUS ESATA QUICK GUIDE

[. . . ] Always shut down the computer before connecting or disconnecting the drive. Connect the included power supply to the back of the drive and to a power outlet. Do not move the drive while it is powered up to avoid drive damage or data loss. NOTE: Never connect the drive to the computer with more than one cable. [. . . ] NOTE: The non-RAID configuration is not supported when the drive is connected to eSATA. If you have files on the drive you want to save, move them to another drive before changing the configuration. *NOTE: The configuration for simple volumes is not supported when the drive is connected to eSATA. Repartition and format your hard drive to complete the volume configuration. Make sure the drive is receiving power (check if the status light is on). Make sure you are using the cable that came with your drive. Make sure the drive is connected to only one interface. pC Users: · Make sure the drive is formatted for use with Windows. If you are connecting to a PCI card, make sure the correct drivers for the card are installed and recognized by your operating system. If you are connecting to USB, check your BIOS to ensure USB is enabled. please refer to your computer's user's guide or manual for instructions. If the drive is still not assigned a drive letter, please visit the support area on www. PC will not start up If your PC will not start up when the drive is connected, the BIOS on the computer probably has a conflict with large capacity removable drives. To work around this problem, power off the drive when starting the computer. Power on the drive after the computer finishes starting up. A complete user's manual in HTML format is available on the support area on www. Iomega warrants this hardware product to be free from defects in materials and workmanship for the warranty period. This non-transferable, limited warranty is only to you, the first end-user purchaser. The warranty begins on the date of purchase and lasts for a period of one (1) year for product purchased in the Americas or the Asia-Pacific region; ninety (90) days for Iomega reconditioned products purchased in these regions; or, two (2) years for product purchased by an end-user in Europe, the Middle East, or Africa. This warranty does not apply to: (a) Iomega software products; (b) expendable components such as fuses or bulbs; or (c) third party products, hardware or software, supplied with the warranted product. Iomega makes no warranty of any kind on such products which, if included, are provided "AS IS. " This warranty also excludes damage caused by accident , misuse , abuse , use of non-Iomega approved media , exposure of media to excessive magnetic fields , or external environmental causes. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more or the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]