User manual ION ILP

[. . . ] Do not connect them to phono-level inputs; iLP's RCA outputs are line-level and could damage a device with phono-level inputs. When you have finished recording, raise iLP's tonearm from the record and return it to its arm clip. PLAYBACK You can listen to the music on your iOS device through its internal speaker or through headphones connected to it. To do this you must first undock your iOS device from iLP. [. . . ] 33 / 45 / 78 Switch* – This switch controls the RPM of the turntable platter. autostop switch – This switch turns autostop on or off. When autostop is on, the platter will start spinning when the tonearm is placed over the record and stop spinning when the record has reached the end. (When autostop is off, the platter will always spin regardless of the position of the tonearm. ) Dock – Connect your iOS device (not included) here to record audio to it from your vinyl. Please see the USING iLP WITH YOUR iPhone, iPad, or iPad touch section of this manual for information on compatible iOS devices and how to record to them. RCA Output** – The audio from a playing vinyl record is sent to this line-level coaxial audio output. This must not be connected to phono level devices. USB Audio Output – Use the included USB cable to connect your turntable to your computer. The USB connection will send audio from the turntable to your computer. Please see the USING iLP WITH YOUR COMPUTER section of this manual for information. Power – Use the included adapter to connect to wall power. Power Button – Press this button to turn iLP on/off. 9 DC 12V 1A 10 11 Mac/PC 12 IMPORTANT: Remove the plastic cartridge cover (needle cover) before operating the turntable. Please only connect these to LINE level inputs. You may damage your receiver if you plug in a LINE level device into a PHONO level input. * If needed, you may adjust the speed of the turntable platter. On the underside of iLP, remove the rubber pads and tighten/loosen the appropriate screw with a screwdriver. 4 TROUBLESHOOTING If you experience any difficulties, please refer to the troubleshooting steps below as well as those in the EZ Vinyl/Tape Converter manual included with this product. I'm not hearing any audio when recording: • If you are recording to an iOS device: o Make sure that iLP is powered on and that the needle is on the record. o Connect iLP's RCA outputs to a stereo system or powered speakers. (Do not connect them to phono-level inputs; iLP's RCA outputs are line-level and could damage a device with phono-level inputs. [. . . ] Click the Audio tab and under Sound recording, select iLP as the default device. windows Vista: Click Start Menu Control Panel (or Settings Control Panel in Classic View) Hardware and Sound Sound. Click the Recording tab and select iLP as the default device. windows 7: Click Start Menu Control Panel Sound. [. . . ]