User manual ION PURE LP

[. . . ] Do not connect them to phono-level inputs; PURE LP's RCA outputs are line-level and could damage a device with phono-level inputs. When you have finished recording, raise PURE LP's tonearm from the record and return it to its arm clip. Com/computer-optimization for more information on optimizing your computer for audio. Playback You can listen to the music on your computer through its internal speakers or through headphones connected to it. [. . . ] * If needed, you may adjust the speed of the turntable platter. On the underside of PURE LP, remove the rubber pads and tighten/loosen the appropriate screw with a screwdriver. **WARNING: The RCA outputs are LINE level. Please only connect these to LINE level inputs. You may damage your receiver if you plug in a LINE level device into a PHONO level input. USB Audio Output – Use the included USB cable to connect your turntable to your computer. The USB connection will send audio from the turntable to your computer. Please see the Using Pure LP With Your Computer section of this manual for information. Power – Use the included adapter to connect to wall power. Power Button – Press this button to turn PURE LP on/off. 4 Troubleshooting If you experience any difficulties, please refer to the troubleshooting steps below as well as those in the EZ Vinyl/Tape Converter manual included with this product. If you are recording to a computer: o Make sure that PURE LP is powered on and that the needle is on the record. O Make PURE LP is selected as your computer's default recording device (see the instructions below). O If you are listening through your computer's speakers, make sure those speakers are selected as your computer's default playback device (see the instructions below). alternatively , you could connect PURE LP's RCA outputs to a stereo system or powered speakers. Do not connect them to phono-level inputs; PURE LP's RCA outputs are line-level and could damage a device with phono-level inputs. (Note: The RCA outputs monitor the signal coming out of the turntable, not the signal coming from your computer. ) o Disconnect then reconnect the USB cable connecting PURE LP to your computer. I'm not hearing any audio when playing music: • If you are playing music from vinyl: o Make sure that PURE LP is powered on and that the needle is on the record. o Connect PURE LP's RCA outputs to a stereo system or powered speakers. (Do not connect them to phono-level inputs; PURE LP's RCA outputs are line-level and could damage a device with phono-level inputs. ) • If you are playing music from your computer: o Make sure your software music player's volume is turned up. [. . . ] Click the Recording tab and select PURE LP as the default device. • Windows 7: Click Start Menu Control Panel Sound. Click the Recording tab and select PURE LP as the default device. € Mac: Click the upper-left "apple" icon then click System Preferences Sound. [. . . ]