User manual ION SLIDES 2PC MK III

[. . . ] Keep SLIDES 2 PC and its accessories out of the reach of children and animals to prevent accidents or damage to the image copier. If you notice smoke or a strange odor coming from SLIDES 2 PC, turn the power off immediately. Take SLIDES 2 PC to the nearest authorized service center for repair. Never attempt to repair SLIDES 2 PC on your own. [. . . ] Insert the installation CD into the CD-ROM drive and the click the CD icon. Open the film holder by lifting the tab on the bottom. Insert the slide(s) into the slide slot(s) or lay the negative over the negative slot. Be sure the latch and sides of the holder are securely in place. Insert one end of the roll of film in the slot on the right-hand side of the holder. Gently push/pull the roll of film through the holder to move from picture to picture. Tip: To avoid laying a negative in the wrong direction (which will produce a mirror image), be sure you can correctly read the serial numbers at the top of the negative when placing it in the holder. With the lever all the way to the right, stack your slides in the rapid slide feeder. Place the rapid slide feeder into the FILM HOLDER SLOT. Push the lever towards the left, then pull the lever back to the right again to load a slide from the feeder into SLIDES 2 PC. Repeat this step for subsequent slides (which will push the used slides out the other side). 5 USING THE SLIDES 2 PC 1 Plug the USB cable of the SLIDES 2 PC into your computer’s USB port. Once connected, the power LED light will be blue. Note for Windows users: The first time you connect SLIDES 2 PC to your computer, wait a few seconds until you see a dialog box that says "Found New Hardware" (this means the computer recognizes the SLIDES 2 PC). After you see this, SLIDES 2 PC is ready to use. 2 Insert the loaded film / slide holder properly into the slot as shown. Click the "folder" icon button and select the location to save your pictures. 6 or Click “Snapshot” on the screen or press the COPY button on SLIDES 2 PC. You can adjust the location of the film by moving the film holder. The maximum is 12 pictures in the preview area. Press the “Save” button to save the pictures to your computer. Note1: To ensure the best image quality, please allow about 5 seconds between snapshots and transfers for white balance enhancement. [. . . ] There is a black border around the edge of the image. The slide or film might not be properly inserted in the holder, or the holder might not be fully inserted into the SLIDES 2 PC. Remove the holder from SLIDES 2 PC and make sure the slide or film is placed correctly in the holder. Reinsert the holder into SLIDES 2 PC (it should click into place when inserted properly). [. . . ]