User manual IRIVER E50

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures : - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. [. . . ] The battery indicator or icon in the lower right corner of a screen begins blinking when the battery must be recharged. To recharge the battery Note If system hangs during battery replacement, remove battery and repeat battery replacement procedure again. Connect the power adapter cord or cradle to a wall outlet and then to your Portable Media Center. An indicator light on your Portable Media Center remains amber while the battery is recharging, and turns green when the battery is fully recharged. The battery indicator or icon displayed on the screen indicates the battery status by the number of horizontal lines inside the icon. A lightning bolt is overlaid on the battery icon while the battery is recharging. The battery could take several hours to fully recharge. - 69 - Digital Media File Types Updating the Software Running on Your Portable Media Center Periodic updates might be available for the software than runs on your Portable Media Center. These updates may contain improvements and new features. To check for updates to the software running on your Portable Media Center Visit www. iriveramerica. com for the latest updates for your Portable Media Center. NoteIf the device is full of contents, then firmware updates will fail for insufficient space. You must delete the contents in the device (up to 180 MB) to make room for the firmware update. - 70 - Digital Media File Types To update the software running on your Portable Media Center a. Use the USB cable to connect your Portable Media Center to the computer. When the following figure appears, click OK to continue. b. The Media Player 10 will appear on your PC screen, just minimize it and run the update program download from www. iriveramerica. com. - 71 - Digital Media File Types c. Click the File tab. d. Select "Connect to Device". - 72 - Digital Media File Types e. Others might not, and in these cases Windows Media Player might acquire the license without notifying you. You can automatically or manually add licensed protected content to your Portable Media Center if the license allows it. Protected files in the Windows Media Player media library whose licenses do not allow them to be copied to portable media devices will not be transferred to your Portable Media Center. Your Portable Media Center plays protected files only if they are licensed. You can play protected files until the license expires. A message appears on the screen when this happens. If a protected file has a license that does not expire, you can play the file indefinitely. Contact the content provider if you have questions about the license terms. - 77 - Protected Content You cannot copy and share licenses among different computers using your Portable Media Center. If your Portable Media Center contains a protected file that is not licensed, an error message appears on the screen if you try to play it. You must download or otherwise acquire a licensed copy of the file and then transfer the licensed copy to your Portable Media Center before you can play it. For more information on acquiring licensed files and managing your licenses, see Windows Media Player Help on this computer. Non-Protected Digital Media Content and Your Portable Media Center Your Portable Media Center stores and plays non-protected digital media files as well as protected files with licenses. [. . . ] Use the Up and Down buttons to select On or Off; then press the OK button. Press the OK button to returns to the Effects screen. To return to the previous screen without making a selection, press the Back button. To return to the Start screen without making a selection, press the Start button. - 126 - Setting Effects Options To set the Sounds option 1. [. . . ]