User manual IROBOT DIRT DOG

[. . . ] Owners Manual SAVE 15% on accessories. See back for details. www. irobot. com Important Safety Instructions CAUTION: DO NOT EXPOSE THE ELECTRONICS OF Dirt Dog, ITS BATTERY OR THE CHARGER. THERE ARE NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. (10V AC) OUTLET ONLY. Always exercise caution when operating your Dirt Dog. [. . . ] Confining Dirt Dog to a single room will accelerate cleaning. The Virtual Wall beam is keyhole shaped. A small halo prevents Dirt Dog from bumping into the Virtual Wall and a larger lobe-shaped section blocks off areas of your home where you don't want Dirt Dog to go. Shape of Beam D Alkaline Batteries Battery Installation The Virtual Wall requires 2 "D" batteries and automatically shuts off after 135 minutes. If the power light blinks green, the batteries will soon need replacement. (not included) Battery Door Range Adjustment Use the slider bar to adjust the length of the barrier. A higher range will drain the battery faster. Range TIP: For best performance, place the Virtual Wall on the outside of the doorway you wish to block. Set the Virtual Wall to the shortest setting possible to extend battery life. TIP: Scheduling Virtual Walls (when programmed) will turn on a few minutes before Dirt Dog. See page 1 for details. Dirt Dog is compatible with Roomba Virtual Walls. Additional Virtual Walls may be purchased at www. irobot. com. www. irobot. com 11 Home BaseTM (optional accessory) Dirt Dog returns to the Home Base at the end of a cleaning cycle or when its battery is running low. Dirt Dog needs to find the infrared signal of the Home Base in order to return. When Dirt Dog is on the Home Base, the Power and Docked lights will be green to indicate Dirt Dog is charging. Home Base Location You should position the Home Base on a hard level surface and in an area where Dirt Dog has a clear path to return to the dock at the end of a cleaning cycle. If Dirt Dog is unable to dock on its first attempt, it will try again until it successfully docks. To manually dock Dirt Dog, place it within five feet of the Home Base and press Spot and Clean simultaneously. You can also drive Dirt Dog toward the Home Base with the remote control, and Dirt Dog will dock automatically. Home Base Chair Table Stairs Area Rug The Dirt Dog Remote, Virtual Wall, and Home Base operate using an invisible infrared technology. If they are all used in the same area, Dirt Dog may see multiple infrared signals and not operate. Dirt Dog WILL NOT dock if you have a Virtual Wall near the Home Base. Fluorescent lights also can impact Virtual Wall and Home Base performance. 1 iRobot Dirt Dog Owner's Manual Remote Control (optional accessory) Spot Directional Buttons Power Clean Max Pause The Dirt Dog Remote Control lets you conveniently control Dirt Dog's functions. You can use it to turn Dirt Dog on and off, and steer it around your room without bending down. It also gives you remote access to the following commands: Clean: Start Dirt Dog in Clean mode Dirt Dog calculates room size and adjusts cleaning time. Dirt Dog runs until battery is depleted. Pause: Pause Dirt Dog in the middle of the cleaning cycle. Before using your remote for the first time, you must install 2 AA batteries (sold separately). TIP: You can use the remote to direct Dirt Dog to the Home Base. [. . . ] Not applicable Dirt Dog's beep codes do not include 7 or 8 beeps. If you are getting an error with 7 or 8 beeps, try counting again or contact iRobot Customer Care. Sensor error Please contact iRobot Customer Care. Dirt Dog is stuck Pick up Dirt Dog and start it again somewhere else. [. . . ]