User manual IROX HRG150

[. . . ] A Mode button - Display of the total rain amount for the past hour, 24 hours and week - Rain display in mm or inch can be selected G" - Setting the desired values - New search for the sensor signal (keep pressed) " arrow button B RAIN GAUGE WITH INDOOR-OUTDOOR THERMOMETER WITH WIRELESS EXTERNAL SENSORS AND RADIO CLOCK (DCF77) - Display of the total rain amount for the past hour, 24 hours and week - Switch between rain amount display for the past hour, 24 hours and week Arrow button H Memory button DISPLAY OF MAX. /MIN. MEMORY By pressing the [MEMORY] button, the display switches between current, minimum and maximum temperature (respective to the corresponding channel) DELETE THE MAX. /MIN. MEMORY Press and hold the [MEMORY] button for about 4 seconds to delete the max. /min. memory of all temperatures. C Memory button - Display of the total rain amount for the past hour, day and week. [. . . ] Once the DCF time signal is received, time and date appear automatically on the display. - Leg support / Wall mount The display unit has a removable leg support. This can be removed and the device can be wall mounted using the opening on the back. The antenna can be set up on a flat surface or wall mounted using the opening on the back. - New rain sensor search The following appears in the rain display if there is no reception " " If this is the case, begin a transmitter search by pressing the [ ] button 2 seconds. This kind of transmitter search lasts ca. 2 minutes and is always advisable whenever data transmission is interrupted or the antenna batteries have been replaced. - Rain amount display In the rain mode, press the MODE button or the MEMORY button to toggle between the following displays: - Rain amount of the past hour - Rain amount of the past 24 hours - Rain amount of the past 7 days Tip: The value in the "Rain amount of the past hour" display can be read as mm/std (or inch/std). - Deleting the saved rain amounts Press and hold the MEMORY button until the value displayed is zero. This resets all rain values in the display unit to zero. - Setting the rain unit (mm or inches) Press and hold the MODE button to toggle between the two units. 4. Putting display unit into operation - Rain measurement mode The rain measurement data is transmitted wirelessly to the antenna. The display device records the entire rain amount for the past hour, the past 24 hours as well as the past 7 days. The rain amount can be displayed in mm or inches. An audio rain alarm can be set to go off when a certain amount of rain per day is exceeded. - Rain data reception As soon as the 2 batteries are inserted into the rain measurement unit, the sensor starts to transmit rain data. As soon as data is received successfully by the display unit, this data is available on the display. 10 11 14 15 - Activating / Deactivating the daily rain alarm 1. Every time the [ALARM] button is pressed in the rain mode, the display switches between current rain data and the rain alarm value ("ALARM HI" appears in the display). When the alarm is deactivated, "OFF" is shown. When the alarm is activated, the programmed value is shown. During alarm display, an alarm can be activated or deactivated with the [ ] or [ ] button. Press the [ALARM] button to display the rain alarm. Press and hold the [ ALARM ] button about 2 seconds until "ALARM HI" starts blinking (OFF or a number appears in the display). Press the [ ] or [ ] button to set the value. [. . . ] You may choose from the three alarm functions described above 2. The hour portion of the wake-up time starts blinking. Use the [ ] or [ ] buttons to select the hour of the alarm time. Press the [ALARM] button again and set the minutes of the alarm time. [. . . ]