User manual IROX JK-18

[. . . ] The icon or will be displayed - When the or is displayed, press and hold [MODE] for 3 seconds to set the selected alarm + - Press to increase the value of a setting - Press to decrease the value of a setting ALARM - Press once to activate the alarm 1, will be shown - Press again to activate the alarm 2, will be shown - Press again to activate both alarm 1 and alarm 2, and shown Battery compartment 2 x 1. 5 batteries of the size AM-4 resp. "AAA" To open: slide lid in the direction of the arrow (indicated on the lid) after the stand has been removed. will be 3. Open the battery compartment of the display device and remove all insulation strips. [. . . ] The time-zone area can be set from -2 to +2 hours. During the setting, the (add hour) or (minus hour) will be shown. Time Zone Setting NOTE: - During the setting mode, if no button is pressed for one minute, the JK-18 will automatically jump back to the current time display. Settings made up to this point will be stored. - With the ZONE setting you can use the JK-18 as a radio controlled alarm clock almost everywhere in Europe. Here are a few examples of countries where the ZONE should be set (all other West European countries are ZONE = 0): -2 hours: Greenland, Azores -1 hour: Great Britain, Ireland, Portugal, Iceland, Canary Islands +1 hour: Greece, Finland, Baltic States, Bulgaria, Cyprus, Israel +2 hours: Russia (Moscow, St. Petersburg) 4. 2 ALARM 4. 2. 1 Setting an alarm JK-18 offers the feature of dual alarm setting, which you are able to set and activate two individual alarms at the same time. Press MODE button to select alarm 1 or 2. If the icon is shown, press and hold the MODE button for 3 seconds to enter the setting mode of the alarm time of AL1. If the icon is shown, press and hold the MODE button for 3 seconds to enter the setting mode of the alarm time of AL2 4. Press + or ­ button to adjust the hours and minutes of the selected alarm. Press MODE button to confirm the setting. Press ALARM button once to activate the alarm 1, will be shown. Press ALARM button again to activate the alarm 2, will be shown. Press ALARM button again to activate both alarm 1 and alarm 2, and will be shown. You are able to set the alarm sound in 5 different modes by the sliding switch (described in section 2. 2). Press ALARM button again to deactivate both alarms. 31 32 4. 2. 3 Stop the alarm A sounding alarm can be interrupted in three ways: 1. During the sounding of the alarm, press the SNOOZE / LIGHT button to start the snooze cycle (1-9 minutes). [. . . ] Please also remember that used batteries should not be thrown in the household rubbish bin but handed in at the designated collection points. The environment will thank you for it! Current Time 6. CARE INSTRUCTIONS - Do not expose the device to extreme temperatures or direct sunlight over longer periods. [. . . ]