User manual IROX TR119

[. . . ] It measures indoor temperature and humidity, and displays weather data collected by the remote weather sensors. It also provides indication of the indoor/outdoor temperature, pressure and humidity trends, and celestial information such as moon phase, and sunrise/set times. The main console unit stores around 3300 weather records without a computer connection. When linked to a computer using the USB cable (incl. ) and software (free download from internet), an unlimited number of weather records can be displayed and saved onto the computer. [. . . ] The "Sunny" icon, as applies to night time, implies clear weather. Understanding the Moon Phase Diagram FULL LAST NEW FRIST UV Mode The current UV intensity is indicated by both its numerical value and a more intuitive display. , by categorizing it into the levels "LOW", "MED", HIGH", V. It is also represented by a face icon that corresponds to the different levels. The main console unit records the daily and weekly maximum UV intensity. Values may be displayed in MED/h or UVI. Accessing UV Mode From the main console unit: Press UP or DOWN until the UV icon flashing. on the display starts 17 Uv table and display UV-Index Symbol Level Intensity Protection 0 -2. 9 3 - 5. 9 6 - 7. 9 8 - 10. 9 11+ weak medium high very high extreme No protection necessary Protection necessary: Hat, t-shirt, sun glasses, sun cream Protection necessary: Hat, t-shirt, sun glasses, sun cream Additional protection necessary: Avoid to stay in unprotected areas Additional protection necessary: Avoid to stay in unprotected areas Resetting the UV Statistics Memory In UV Mode, press and hold MEM or MEMORY to reset all UV statistics. Setting Units for UV Display (MED/h or UVI) In UV Mode, press and hold SET to convert units between MED/h and UVI. Clock and Alarm Mode The main console unit can be configured to display the time, calendar or UTC time. There are three time alarms available on the console unit: Single alarm: activated once at specified time Weekday alarm: activated everyday from Monday to Friday at specified time Pre-alarm: activated at specified time interval (Fixed 30 min) ahead of weekday alarm, if channel 1 temperature falling to +2 ºC or below. The snooze duration for the above alarms can also be programmed (0-15 min). Press and hold ALARM until hour starts flashing in the display 3. Set Alarm Hour: Press UP or DOWN to adjust value. Press and hold either button for fast advance. Set Alarm Minutes: Press UP or DOWN to adjust value. Press and hold either button for fast advance. Set Duration of Snooze Function (all three alarms share same snooze time duration): Press UP or DOWN to adjust value. Press and hold either button for fast advance. Upon completion the display will be returned to the alarm selection screen. Note: Pre-alarm is only active if one of the alarm has been enabled. The pre-alarm will activate a set alarm 30 minutes earlier if the temperature of Channel 1 fall at +2°C or below. Disabling/Entering Snooze when Time Alarms are Activated To Enter Snooze: Press LIGHT/SNOOZE to enable snooze function. [. . . ] Although wireless signals can pass through solid objects and walls, the sensor should ideally be within the line of sight of the console unit. The following may be the cause of reception problems: - Distance between remote sensor and main console unit too long. (Maximum transmission distance in open area conditions is 100m) - Signal shielding materials such as metal surfaces, concrete walls or dense vegetation in the path of transmission. - Interferences from wireless devices (such as cordless phones, radio headsets, baby listening devices) and electronic appliances. [. . . ]