User manual IROX TRAVEL X

[. . . ] UNFOLDING TABLE STAND SUPPORT * Keeps the unit in an upright position on a flat surface. 5 B MULTIBAND ALARM B. ALARM BUTTON * Allows toggling between CLOCK and ALARM display modes * Enables or disables WEEKLY or SINGLE alarm 4 TOP VIEW J SNOOZE ALL SEGMENTS DISPLAY OVERVIEW H · LIGHT G h ig e f b I G. UP (+) BUTTON * Increases all function parameters * Selects the date display format (date-month or month-date) * Activates Single or Weekly Alarm in ALARM mode H. DOWN (­) BUTTON * Decreases all function parameters * Sets the language for the day of the week * Activates the radio controlled time receiver * Enables or disables any of the alarms I. [. . . ] The mode is selected correctly if the abbreviation "DST" is displayed on the top left corner of the display and the word "Auto" is on the top right one. * Press and hold the MODE button until the "DST" and "Auto" will flash * Press UP (+) or DOWN (-) buttons selecting the setting for Daylight Savings Time ­ ON, OFF or Auto. * After the desired setting is selected press the MODE button to confirm the selection. If the "ON" or "AUTO" is selected, the clock will automatically synchronize with the Daylight Savings Time in spring and fall. If Daylight Savings Time does not apply to your geographic area, an "OFF" setting has to be selected. RF RECEPTION MODE RECEPTION MODE SELECTION You can choose between the auto-scan, single-band reception and RF reception OFF modes. * Enter the RF RECEPTION mode by pressing the MODE button until the abbreviation "SEL" is displayed. * Press and hold the MODE button for 2 seconds ­ the reception icon [ ] will start to flash along with the line above AUTO. * Press UP (+) to select the auto-scan (AUTO), singleband (SEL) or reception OFF (OFF). * Press MODE to confirm the selected reception type. 10 SINGLE COUNTRY RF BAND RECEPTION (SEL) * Once the SEL (Single Country Band reception) is selected, the abbreviation SEL will flash with AUTO and all countries abbreviations underlined. * Press UP (+) or DOWN (-) selecting the desired single reception band ­ WWVB-60(US), MSF-60(UK), DCF-77. 5(EUR), HBG-75(SWISS), JJY40(JPE) or JJY60 (JPW). * Once the desired band is selected, press the MODE button to confirm. The relevant country abbreviation will be underlined and will remain on the display. MANUAL ACTIVATION OF THE RADIO CONTROLLED TIME SIGNAL SEARCH Press and hold the UP (+) button in any mode - the unit will beep once and the reception bars will appear above the reception icon. DISABLING THE ATOMIC RADIO CONTROLLED TIME SIGNAL SEARCH Press and hold the DOWN (­) button in any display mode ­ the unit will beep once and the reception bars will disappear from the left corner, leaving just a dot reception icon. RADIO SIGNAL RECEPTION ICON ( ) Once the reception mode is activated, the radio reception [ ] icon will start flashing. The wave above the dot icon shows the radio signal reception strength. The strength of the reception is shown in the range from zero (weakest) to six (strongest) bars. [. . . ] NOTE: If the battery power is low, the backlight cannot be activated. INDOOR TEMPERATURE The indoor temperature shares the same display's line with time. The temperature reading is updated every minute. NOTE: If the indoor temperature goes above or below the operating range stated in the specifications, the display will show "HH" or "LL" respectively. [. . . ]