User manual ISEKI BOLENS G152

[. . . ] 8 When installing the appliance, an omnipolar circuit breaker with a minimum contact opening of 3 mm or more should be fitted. 9 This appliance must only be used for the purpose for which it was expressly designed. Any other use (such as heating a room for example) is considered to be improper and consequently dangerous. The manufacturer denies all responsibility for damage resulting from improper or incorrect use of the appliance. [. . . ] 22 Metal items such as knives, forks, spoons or lids should not be placed on the hob surface, as they could overheat. 9 Installation The following instructions are intended for a qualified fitter to guide him/her along the installation, adjustment and technical maintenance procedures as correctly as possible and in full compliance with the applicable norms in force. Important: unplug the appliance before all operations (adjustment, maintenance, etc. Built-in hob installation The hobs feature a degree of protection against excessive heating, consequently, they may only be installed next to furniture cabinets which are higher than the hob surface itself. Keep to the following instructions to ensure the correct installation of hobs: a) Any cooker hoods should be installed according to the instructions and guidelines provided by the hood manufacturer. B) Built-in glass ceramic hobs can be installed on any worktop with at least 600 mm depth as long as the latter is made of materials which can withstand temperatures of up to 100°C. 595 Before proceeding with fastening the hob to the top, fit the seal (provided) along the perimeter of the hob as illustrated in the figure. Fastening hooks are foreseen, allowing you to secure the hob to tops ranging from 40 to 60 mm in thickness. To ensure the hob is securely fastened to the top, we recommend you use all the hooks provided. Hook fastening diagram 48 51 0 10 Distance to keep between the cut-out slot and the cabinet 1 56 0+ /- 1 49 0+ /- Hook position for tops H = 40 mm Hook position for tops H = 60 mm These dimensions must be respected at all costs as an incorrect installation could cause the surfaces all around the hob to overheat. The hob should be positioned at least 40 mm away from the back wall or any other vertical surface in order to allow for correct ventilation and to prevent the surfaces around the appliance from overheating. €¢ 4 timers to programme all the cooking zones independently for up to a maximum of 99 minutes. • electronic touch controls. It is easy to tell which control corresponds to which cooking zone: the silk screen printing of the controls and timers is identical to the cooking zone silk screen printing on the hob. • electronic touch controls. To turn the hob off: • press key ; the appliance has been turned off. Make sure you unlock the hob controls before turning it off. To speed up the rise in temperature on the front left cooking zone, • press the" booster" key , "P" will come up on the power display. The booster function comes to an automatic stop after 4 minutes. When the booster function is on, the front right cooking zone is limited to a maximum power of 600W. P Programming The 4 cooking zones can be programmed simultaneously for up to a maximum of 99 minutes. Turning on the hob When you connect the hob to the power supply, a beep will sound after a few seconds: now you can turn the hob on by pressing key . [. . . ] The letter will disappear as soon as the temperature drops back down to an acceptable level. SUITABLE UNSUITABLE Safety cut out If the user inadvertently forgets to turn off one or more cooking zones, the corresponding control is automatically put out of order after a given amount of time (see table opposite). To re-enable the controls, press key off. Do not leave water or other liquids to stagnate on the control panel in order to avoid any unexpected problems. [. . . ]