User manual ISOUND DREAM TIME

[. . . ] n e t Page 1 Page 2 Install/Replace Battery on the Remote Control The remote's battery is factory installed. Open the battery compartment door and remove the protective battery sheet before use. When the remote's battery becomes weak, replace the battery with a (TYPE CR2032 3V Lithium Battery). [. . . ] Press the ALARM 1 button to confirm the ALARM time and wake-up SOURCE. AC Power Supply Connection 1. Insert 2 "AA" batteries, check that the polarity (+ & - ends of the batteries) match the engraving inside the battery compartment. Install/Replace Back-up Battery of the dreamTIME This unit uses a back-up system to provide conitinous clock operation in the event of a power failure. If the Back-up Battery has been installed and a power failure occurs or the AC cord is accidentlly disconnected, the current time and alarm settings will be temporarily maintained. Otherwise, you must reset the time and alarm settings. Selecting Audio Source 1. With the dreamTIME powered on, press the STANDBY/SOURCE button to toggle the different sources. Adjusting the Volume 1. Press the volume up or volume down buttons. The LCD will the volume level. Setting Alarm 2 1. Power the dreamTIME speaker "OFF" . Press and hold the ALARM 2 button for two seconds. The ALARM 2 icon flashes and the HOUR and MINUTE digits start to flash. Follow the same procedures as setting ALARM 1. Installing Back-Up Batteries 1. Make sure the AC adapter is connected or you may lose all of your current settings. Open the battery compartment on the bottom of the unit. Insert 2 "AA" batteries, check that the polarity(+& - ends of the batteries) match the engraving inside the battery compartment. [. . . ] Press and hold CLOCK for about 2 seconds, the LCD backlight illuminates and the HOUR and MINUTES digits start to flash. Press TUNE/TRACK up or down to set the HOUR, press VOLUME up or DOWN to set the minutes. Press CLOCK to confirm the HOUR/MINUTES, the digits will stop flashing. [. . . ]