User manual ITI ADVENT COMMERCIAL FIRE SYSTEM REV B

[. . . ] 60-562-03 60-562-06 $GYHQW &RPPHUFLDO )LUH 6\VWHP Document Number: 466-1705 Rev. B November 2001 User's Manual System Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Using the Touchpad Buttons . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 General Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Do not use phone number sequences which others may know. Keep a separate log of all programmed user codes and their user names in a secured location. 3. Enter the area to redi- System displays arming status for rect the touchpad to. that area. Global Status and History If partitions have been turned into areas, the user can also check for global status and history. Selecting global status allows the user to view the following: Whether any alarms are active in any enabled area. Whether a battery test, LED test, or download is in progress. Status of main power and main battery. AdventTM Commercial Fire System 3 Access Codes To add an access code: To list access codes: Steps 1. Enter your primary ACCESS CODE. Response SECURITY MENU; ENTER YOUR CODE ACCESS CODE MENU ENTER THE NEW CODE THEN PRESS Steps 1. Press 3. Response SECURITY MENU; ENTER YOUR CODE ACCESS CODE MENU USER 3. Press * twice to exit. # CODE XXXX NO TEXT AUTH:X LIM:X ENTER THE CODE A SECOND TIME THEN PRESS # CODE OK Note No two access codes can be alike. If you are unsuccessful adding an access code, make sure the new access code doesn't already exist in the system. To check the existing codes, from the main menu select 1, 8, your access code, and 3. For LIM you can have the following options: P = Permanent, D = Day, and U = Use. For AUTH, you can have the following options: P = Partition, F = Full, or 1-8. If there is a * the code is a global code. Press * twice to exit. MAIN MENU Changing an Access Code To ensure maximum security, access codes should be changed on a regular (monthly) basis. You should also change an access code if you suspect an unauthorized person knows a user's access code or if/when a user is replaced. To change an access code: Deleting an Access Code Delete an access code when you no longer want that code to allow access to the system. To ensure maximum security, delete access codes as soon as they are no longer needed. To delete an access code: Steps 1. Enter the ACCESS CODE to delete and press #. Press * twice to exit. Response SECURITY MENU; ENTER YOUR CODE ACCESS CODE MENU ENTER THE CODE TO DELETE THEN PRESS # CODE DELETED Steps 1. Enter your primary ACCESS CODE. Response SECURITY MENU; ENTER YOUR CODE ACCESS CODE MENU ENTER THE CODE TO CHANGE THEN PRESS # ENTER THE NEW CODE THEN PRESS ENTER THE CODE A SECOND TIME THEN PRESS # CODE OK 3. Enter the ACCESS CODE to change and press #. Enter the new ACCESS CODE again and press # Note If you are unsuccessful deleting an access code, make sure the access code exists in the system. [. . . ] To perform a fire drill: Checking the Alarm History Checking the alarm history lets you know which and how many alarms have been logged into memory. There can be a maximum of 16 alarms stored in the alarm history. These are listed from the newest alarm to the oldest alarm with the oldest being automatically deleted when a new alarm is logged. A flashing * notifies you when there have been any new alarms. [. . . ]