User manual JABRA BT250V

[. . . ] 4 "Pair" to your Bluetooth® phone . Thank you for purchasing the Jabra BT250v Bluetooth® Headset, we hope you will be delighted with its operation. Please read the instruction manual to get started and to make best use of the headset's many features. The Jabra BT250v is compatible with most Bluetooth¹ (see Glossary) phones that are compliant with Bluetooth version 1. [. . . ] Enhanced features are available for phones that support the hands-free Bluetooth profile such as Nokia 3600, 3650, 6310, 6310i, 8910, 8910i, Sony Ericsson T610, T616, T618, Siemens S55 and S56. Check your phone's instruction guide or contact the phone manufacturer if you are not sure if your phone supports the hands-free Bluetooth profile. You can enable these enhanced features by using the following alternative pairing sequence. Press and hold and also press the volume up button until you see a solid blue light (approximately 8 seconds), then release (see Fig. Set your Bluetooth phone to "discover" the headset by following your phone's instruction guide. Typically, the steps involve going to a "setup, ""connect, " or "Bluetooth" menu on your phone and then selecting the option to "discover" a Bluetooth device*. Your phone will find the "Jabra BT250v" headset and ask if you want to pair with it. Enter passkey or PIN = 0000 (4 zeros), then press "yes" or "ok. If the headset is not responding or the blue light will not turn on or off after pairing, you may need to RESET your headset. Leave the headset in the charging cradle for about 3 seconds, then remove the headset (see Fig. (Such as Nokia 6310 and 8910 series) Please ensure that the headset is allowed by the phone to connect without authorization. To do this, you must adjust your phone's settings. * Phone-specific pairing instructions and the most current list of phones with hands-free profile can be found online at www. IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly before going back to flashing every 3 seconds. If unsuccessful, the light remains solid, and you'll need to reattempt pairing (see steps 3­5 above). Once you're done pairing, the following new headset features will be available: Last number redial (when not on a call) While the headset is on, press and hold until you hear 2 short beeps, release immediately Rejecting an incoming call (when not on a call) When your phone rings, press and hold until you hear 2 short beeps, release immediately Call-waiting (swapping between 2 calls) When your phone notifies you of another incoming call while you're on a call, press and hold until you hear 2 short beeps, release immediately Putting a call on hold While you're on a call, press and hold until you hear 2 short beeps, release immediately. Repeat to retrieve the call Can other Bluetooth phone users hear my conversation?When you pair your headset to your Bluetooth phone, you are creating a private link between only these two Bluetooth devices. The wireless Bluetooth technology used in your headset is not easily monitored by third parties because Bluetooth wireless signals are significantly lower in radio frequency power than those produced by a typical mobile phone. the MiniGel is made of PVC (polyvinyl chloride) , a form of plastic. The headset itself is primarily made of thermoplastic polyurethane, which is a soft plastic. The face of the headset, where the buttons are located, is made of polycarbonate, a very strong, hard plastic. [. . . ] The term "IC:" before the certification/registration number only signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. This warranty does not apply to:"open box purchases", resales by private parties or any other third party purchases by unauthorized distributors. Transfer of Jabra products through any unauthorized distributor renders our manufacturer's warranty null and void. BUYER BEWARE: any Jabra product sold by a private party or unauthorized distributor and not by an authorized Jabra retail seller is sold on an "as is" or "with all faults"basis with respect to Jabra. [. . . ]