User manual JAMO 1A2

[. . . ] Cover the screws with four screw plugs (g) fig. Into account the weight of the speaker (speci cations on back). A hole (f) the middle of the bracket allows for running the speaker wire through t Mounting of port plugs If the front of the desired. Cover the screws with bass reflex ports (under (g) bracket if so speaker is exposed to rain directly entering the four screw plugsthe fig. [. . . ] mounting of speaker Place the speaker inside the curved bracket as shown in fig. 2 and insert thumb screws (j) through each end of the curved bracket into the speaker. The curved bracket can be ad-justed in the wall bracket by loosening the two ½" allen bolts (e) and re-tighten them after adjustment. Painting The speaker and bracket can be painted. Remove the grill from the speaker before painting and cover the front baffle (l) of the speaker. Apply many thin coats instead of a few thick coats to avoid the paint running or clogging the grill holes. In case of request for service under warranty, please enclose your original receipt and make sure that the serial number on the product is readable. Important: Never send the product to be repaired without the prior agreement of your dealer. the product must always be packed properly. If the product is NOT UNDER WARRANTY, all costs including without limit costs of repair and freight must be paid for by the customer. Nothing in this warranty shall limit your statutory rights. The warranty is only valid on presentation of the original sales receipt or other valid proof of purchase, and provided that the serial number on the product is fully legible. Warranty repairs must be carried out by an authorised Jamo dealer, or an authorised service centre. no payment will be made for repairs performed by unauthorised persons. This warranty does not extend to products which have been repaired or otherwise altered by unauthorised persons, and any damage to the product caused by work by unauthorised persons is not covered by this warranty. This product will not be considered defective, either in materials or in manufacture, to the extent that faults are caused by adaptation to national, local, technical or safety related requirements in countries other than the specific country where the product was purchased. Jamo shall at its option during the relevant warranty period either repair or replace defective components. In no circumstances shall Jamo be liable in contract, tort (including negligence) or breach of statutory duty or otherwise for loss of profits, loss of revenue, loss of data, loss of business or loss of anticipated savings or for any consequential loss whatever. [. . . ] Into account the weight of the speaker (speci cations on back). A hole (f) Fixation du porte-prises the middle of the bracket allows for running the speaker wire through t Si l'avant bracketde l'enceinte est exposé directement à la pluiewith four évents deplugs (g) fig. Cover the screws menant aux screw résonance (sous la grille), les ports doivent être bouchés pour éviter l'inondation des haut-parleurs. Fixation du support Le support peut être fixé de manière à y placer une enceinte à l'horizontale ou à la verticale. [. . . ]