User manual JANE EXO

[. . . ] it is advisable to install it on the back seat. If you fit it onto the front seat of the vehicle, it must NOT be fitted with an AIR BAG or it must be disconnected. It is only valid for vehicles fitted with automatic 3-point seat belts, certified under regulation ECE-16 or other equivalent regulations. Not all safety systems are exactly the same, therefore we recommend you test your EXO in the vehicle in which it is going to be fitted. [. . . ] 1b Guide both fasteners towards the axles and press until both sides are locked, two green lights on the front panel (11b) or two green signals on the fasteners (10) will indicate that both are fastened. If one or both lights and / or signals are red, try it again. 1c Pulling the fastener extraction lever again (12), press the seat against the backrest of the vehicle. Continue to press while releasing the lever and the fasteners will remain immobile. 1f Lastly, tighten the strap until the red signal disappears from the tension indicator (14c). The lights on the front panel (11c) will light up in red. You can store the ISOfix fasteners by pulling the front lever (12) and pressing the fasteners inside the base. 2 Installation with a three-point seat belt. A Place the EXO seat in its most reclined position (see 5, adjusting the backrest) and turn the tightening lever (18) towards the rear part of the seat. Pass the buckle of the three-point seat belt between the base and the seat (15) and fasten it. B Slide the shoulder strap of the vehicle seat belt through the clip (16) on the top part of the seat, only the one on the side opposite to the buckle. C Press the EXO against the seat and manually tighten the vehicle seat belt. D Pass the strap through the red ring (17) of the seat E Lastly, turn the tightening lever (18) towards the front of the seat. To make it easier to install the baby in the seat, you can fasten the seat belts in the side straps. C Position the baby in the seat making sure that he is sitting as far back as possible and with the backrest upright. Join together the upper ends of the buckles. D Insert them in the lock and press until it clicks. With the child correctly seated in the seat check that the shoulder straps are in the correct position, they should be slightly above the baby's shoulders. 4b Move the headrest (3) into the position suitable for the baby and release the ring. The EXO seat is reclined by using a lever situated on the front part of the seat (19). [. . . ] do not recharge non-rechargeable batteries. Remove dead batteries from the electronic detection system. Do not cause short circuits in the terminals. Always keep the packaging out of the child's reach. [. . . ]