User manual JANOME S7

[. . . ] When using an electrical appliance, basic safety precautions should always be followed, including the following: This sewing machine is designed and manufactured for household use only. Read all instructions before using this sewing machine. An appliance should never be left unattended when plugged in. Always unplug this sewing machine from the electric outlet immediately after using and before cleaning. [. . . ] Remove the fabric from the machine and cut the sewing threads only. C Cut the filler cord at both ends as close to the buttonhole as possible. NOTE: Do not adjust the opening width wider than 0. Set the stitch width in accordance with the thickness of the cord used. To cut the buttonhole opening, refer to the instructions on page 39. Z Attach the automatic buttonhole foot R and pull the button holder all the way out. Place the fabric under the foot, and lower the needle at the starting point. q Button holder w Starting point X Start the machine and sew to the required length, then press the reverse button. Continue sewing until the machine stops automatically. e Reverse button r Required length C Sew another layer of darning over the first layer, at a right angle to it. To sew the same size darning When finished sewing, a confirmation message will appear. Simply start the machine to sew another layer of darning stitches in the same size. To sew the next layer of darning stitches in a different size, press the X key. Sew the first line to the desired length and stop the Press the reverse button and start the machine again. The machine will sew the rest of the darning and stop To adjust the evenness of darning stitches You can correct unevenness of darning stitches by pressing the "­" or "+" key of the adjusting window. If the left corner is lower than the right side, press the "­" key to correct it. If the right corner is lower than the left side, press the "+" key to correct it. To sew: Place the garment under the foot and lower the needle to the starting point. Sew until the machine stops automatically. Q Starting point Open the eyelet with an awl, puncher or pointed scissors. q To correct the shape of an eyelet: If the eyelet is open, press the "­" key. If the eyelet overlaps, press the "+" key. [. . . ] A blue tip needle is not being used for sewing stretch, very fine fabrics Use the stretch stitch The needle thread is not threaded properly. A purple tip needle is not being used for sewing thick fabrics, denims Page 16 The needle thread tension is too tight. The needle thread is not threaded properly. The needle is too heavy for the fabric being sewn. [. . . ]