User manual JBL 702VXA

[. . . ] · Refer to "Home Theater" below if you also plan to use the speakers in a home theater system. SPEAKER CONNECTIONS CONNECTION TIPS HOME THEATER For front-channel use, place one speaker on the left and another on the right along either side of the television. A center channel speaker should go directly above or below the television and can be an in-wall, in-ceiling or freestanding center channel. For left and right surround channels, place one speaker on the left and another on the right, to the side of or slightly behind the listening area. In 6- or 7-channel configurations, place the rear channel(s) behind the listening position, as shown in Figure 3. [. . . ] Proper placement of the speakers is an important step in obtaining the most realistic soundstage possible. These recommendations are for the optimal placement of the loudspeakers. Use these placement recommendations as a guide. Slight variations will not diminish your listening pleasure. Figure 4. Recommended Size 16-gauge 12-gauge INSTALLATION The StudioTM L Series in-wall and in-ceiling speakers were designed to be easily installed. However, if you are unable to clearly and fully understand and follow the instructions in this manual, or if you are unsure of your ability to properly install these loudspeakers, please contact your dealer or a qualified installer. TOOLS NEEDED TURN OFF ALL POWER Before completing the installation, you must connect your speakers to your system. Use high-quality speaker wire to make your connections. Use at least #16-gauge speaker wire with polarity coding. Heavier gauge wire is recommended for larger distances. Consult the chart above or your dealer for recommendations. NOTE: Use the included template when cutting the drywall. 3. NOTE: Always allow at least a 1/2 inch between a wall stud and the speaker cutout or the locking tabs will not be able to swivel into place. 4. Ensure that the drywall or plywood board or other appropriate wallboard is at least 1/2-inch thick and confirm that the board material is capable of withstanding the weight of the speaker you will be installing. Connect the speaker wires to the speaker. 6. Make sure all four locking tabs are properly positioned against the locking tab stops that are located on the speaker frame (see Figure 6 below). After confirming this, carefully place the frame assembly in the wall and confirm that there is no more than 1/8-inch play between the frame and the wall cutout. After positioning the speaker in the mounting location, back each screw out one full turn (turn counterclockwise). 7. Screw down each of the four Phillips-head screws, alternating between the four screws. The locking tabs will swivel into place and secure the unit to the rear surface of the wall panel. Handtighten with a nonpowered, straight-handle regular screwdriver only. Do not use a socket wrench, a powered screwdriver, a drill or any other powered tool. [. . . ] Attach the metal grille and logo, if desired. Figure 6. 5 NEW CONSTRUCTION If you wish to preinstall a rough-in frame before the drywall is installed, you will need to purchase the correct rough-in-frame kit for your model: Speaker Model Rough-In-Frame Kit L226W, 702VXA RIF 6 L226C, LS326C RIF 6CS L228C, LS328C RIF 8C Detailed installation instructions are supplied with the rough-in kit. PAINTING THE SPEAKER FRAME AND GRILLE Studio L in-wall and in-ceiling loudspeakers can be painted to match any décor. If you wish to change their color, the satin finish on the grille and frame will function as a primer coat. Before painting, install the paint shield (inner section of template in the assembly kit) securely into the recess in the baffle. This will protect the speaker components and baffle from paint residue. [. . . ]