User manual JBL AVR 480

[. . . ] We strongly recommend that you read the Owner's Manual for complete details on how to install, configure and operate the AVR480, as well as for the important safety information it contains. FIGURE 1 - SPEAKER PLACEMENT The colors shown for each speaker correspond to the matching output terminal connection on the back of the AVR480 (see page 10). FRONT LEFT SPEAKER CENTER SPEAKER (Green) FRONT RIGHT SPEAKER (Red) (White) SURROUND RIGHT SPEAKER SUBWOOFER (Purple) (Gray) CONNECTIONS COLOR GUIDE Audio Connections Front Center Surround Subwoofer Digital Audio Connections Coax Optical Video Connections Composite S-Video Match the colored jacks on the AVR480 to the appropriate jacks on your source equipment or speakers. The colors are standardized, but not all equipment or connectors use them. SURROUND LEFT SPEAKER Left Right (Blue) Step 1. [. . . ] Region Selection: Set the Region Selector to "K" for South Korea. Set it to "C" for China or Hong Kong. Set it to "S" for Singapore, Malaysia, Indonesia or Thailand. (For other countries, please consult your local JBL distributor. ) The Main Power Switch (not just Standby) must be turned off, then on again, in order for this selection to take effect (see page 31). Depending on the electrical requirements in your area, you may need to contact your JBL dealer to obtain the correct power cord. Plug all components into AC power outlets. Select digital inputs: If your DVD is connected to the Coax input, no adjustment is needed. For another digital device, use the front-panel Digital Select button and the arrow buttons to select the optical digital input (see pages 18 and 27). Select a surround mode: Press the Surround Mode button on the front panel to select Dolby ® Pro Logic ® II ­ Movie. (You may select other modes later as you become familiar with the AVR480; see pages 25­29. ) Step 10. Configure speakers: No action is needed if you have five "small" satellite-type speakers and a subwoofer. Otherwise, press the Speaker button and then the Set and arrow buttons to select the correct speaker choices for your system (see pages 19­20). [. . . ] The Video 3 inputs are on the front panel of the receiver. Device CD Player DVD Player VCR Audio Recorder TV or Projector Input Name CD DVD Video 1 Tape TV Audio Input Connections CD, Optical Digital Coaxial Digital Video 1 L/R Inputs Video 2 L/R Inputs, Optical or Coaxial Digital Input* Tape L/R Inputs, Digital Coaxial Input** TV L/R Inputs Audio Output Connections Not required Not required Video 1 L/R Outputs Not required Tape L/R Outputs, Digital Coaxial Output** Not required Video Connections Not required DVD Composite or S-Video Video 1 Composite or S-Video Input and Output Video 2 Composite Input Not required Monitor-Out Composite and/or S-Video Cable Box or Satellite Receiver Video 2 * Check with your cable service provider to determine whether digital audio is available for all channels. [. . . ]