User manual JBL AVR 580

[. . . ] We strongly recommend that you read the Owner's Manual for complete details on how to install, configure and operate the AVR580, as well as for the important safety information it contains. FIGURE 1 ­ SPEAKER PLACEMENT The colors shown for each speaker correspond to the matching output terminal connection on the back of the AVR580 (see page 9). FRONT LEFT SPEAKER CENTER SPEAKER (Green) FRONT RIGHT SPEAKER (Red) (White) SURROUND RIGHT SPEAKER SUBWOOFER (Purple) (Gray) CONNECTIONS COLOR GUIDE Audio Connections Front Center Surround Subwoofer Surround Back Digital Audio Connections Coax Optical Video Connections Composite S-Video Match the colored jacks on the AVR580 to the appropriate jacks on your source equipment or speakers. The colors are standardized, but not all equipment or connectors use them. Left Right SURROUND LEFT SPEAKER (Blue) SURROUND BACK LEFT SPEAKER (Brown) SURROUND BACK RIGHT SPEAKER (Tan) Step 1. [. . . ] Connect the component, composite and S-Video Monitor outputs to your Video Monitor (TV). Switch your TV set's input to match the type of video used for the currently selected source. Step 6. Region Selection: Set the Region Selector to "K" for South Korea. Set it to "C" for China or Hong Kong. Set it to "S" for Singapore, Malaysia, Indonesia or Thailand. (For other countries, please consult your local JBL distributor. ) The Main Power Switch (not just Standby) must be turned off, then on again, in order for this selection to take effect (see page 35). Depending on the electrical requirements in your area, you may need to contact your JBL dealer to obtain the correct power cord. Plug all components into AC power outlets. Select digital inputs: If your DVD is connected to Coax 1, no adjustment is needed. For any other digital-device connections, use the front-panel Digital Select button and the arrow buttons to select an optical or coax digital input (see pages 22 and 32). Select a surround mode: Press the Surround Mode button on the front panel to select Dolby ® Pro Logic ® II ­ Movie. (You may select other modes later as you become familiar with the AVR580; see pages 22­24 and 31­35. ) Step 10. [. . . ] The Video 4, Coax 3 and Optical 3 inputs are on the front panel of the receiver. Device CD Player DVD Player VCR Cable Box or Satellite Receiver Audio Recorder TV or Projector Input Name CD DVD Video 1 Video 2 Tape Video 3 Audio Input Connections CD L/R Inputs, Optical Digital 1 or 2, or Coaxial Digital 1 or 2 Coaxial Digital 1 or 2, Optical Digital 1 or 2, or DVD L/R Inputs Video 1 L/R Inputs Video 2 L/R Inputs, Optical Digital 3* or Coaxial Digital 3* Inputs , Tape L/R Inputs, Optical Digital 1/2** or Coaxial Digital 1/2** Inputs Video 3 L/R Inputs Audio Output Connections Not required Not required Video 1 L/R Outputs Not required Tape L/R Outputs, Digital Optical** or Coaxial Outputs** Not required Video Connections Not required Component, Video 2, DVD Composite or S-Video Video 1 Composite or S-Video Input and Output Component Video 2, Video 2 Composite or S-Video Input Not required Monitor-Out Component, Composite and/or S-Video * Check with your cable service provider to determine whether digital audio is available for all channels. [. . . ]