User manual JBL BALCONY

[. . . ] · Position each speaker so that the tweeter is approximately at ear level. · Generally, bass output will increase as the speaker is moved closer to a wall or corner. · Refer to "Home Theater" below if you also plan to use the speakers for home theater reproduction. Figure 2. [. . . ] When installing screws in any wall, always use properly selected wall anchors. Attach two of the four self-adhesive rubber pads that came with the Balcony loudspeaker to the back of the enclosure in the two bottom corners so that the cabinet is spaced evenly from the wall. Select a suitable mounting location on a wall. (The ceiling is not a suitable mounting location. ) Drill two pilot holes, appropriately sized for the specific self-tapping screw or wall anchor that you will be using. The holes should be 8 inches (203mm) apart. The holes should be 3/4" (19mm) below where you want the top of the enclosure to be positioned. Use a carpenter's level to ensure that the holes are even and that the speaker will mount on the level. Install the two screws into either a wooden wall stud or anchor, and tighten them until the back of each screw head is about 1/8 inch (3mm) from the wall. Install the loudspeaker by slowly moving the cabinet toward the screws so that the screw heads clear the larger circular portion of the two keyholes. Once both screw heads have entered the keyholes, the loudspeaker should gently be lowered onto the screw shafts. Check that the loudspeaker is firmly locked onto the screws by gently pulling the speaker down and forward. Figure 4. This figure shows how to connect bare wires to the terminals. STANDARD CONNECTION Figure 5. Wiring diagram shows polarity connections for one channel of a stereo or home theater system. FINAL ADJUSTMENTS Check the speakers for playback, first by setting the system volume control to a minimum level, and then by applying power to your audio system. Play a favorite music or video segment and increase the system volume control to a comfortable level. [. . . ] NOTE: Do not use any cleaning products or polishes on the cabinet or grille. 3 SPECIFICATIONS TOUR Frequency Response (­3dB) Max. Recommended Amplifier Power* Power Handling (Continuous/Peak) Sensitivity (2. 83V/1m) Nominal Impedance Crossover Frequency Low-Frequency Transducer Midrange Transducer High-Frequency Transducer 70Hz ­ 20kHz 100W 50W/100W 86dB 8 Ohms 3000Hz 4" (102mm) PolyPlas, TM shielded NA 3/4" (19mm) Titaniumlaminate dome, shielded, EOSTM waveguide 9-1/2" x 6-3/4" x 5-5/8" 241mm x 171mm x 143mm 4. 6 lb/2. 1kg MONITOR 68Hz ­ 20kHz 125W 60W/240W 86dB 8 Ohms 3000Hz 5" (130mm) PolyPlas, TM shielded NA 3/4" (19mm) Titaniumlaminate dome, shielded, EOSTM waveguide 10-7/8" x 6" x 8-5/8" 275mm x 153mm x 219mm 7 lb/3. 2kg ARENA 50Hz ­ 20kHz 125W 70W/280W 88dB 8 Ohms 4000Hz 6" (170mm) PolyPlas, TM shielded NA 3/4" (19mm) Titaniumlaminate dome, shielded, EOSTM waveguide 15" x 9" x 11-1/4" 381mm x 229mm x 286mm 15 lb/6. 8kg STAGE 47Hz ­ 20kHz 150W 80W/320W 90dB 8 Ohms 600Hz, 3500Hz 6" (170mm) PolyPlas, TM shielded 4" (100mm) PolyPlas, TM shielded 3/4" (19mm) Titaniumlaminate dome, shielded, EOSTM waveguide 34-3/4" x 9" x 13-1/8" 883mm x 229mm x 333mm 31. 2 lb/14. 5kg Dimensions With Grille (H x W x D) Weight per Speaker STADIUM Frequency Response (­3dB) Max. Recommended Amplifier Power* Power Handling (Continuous/Peak) Sensitivity (2. 83V/1m) Nominal Impedance Crossover Frequencies Low-Frequency Transducers Midrange Transducer High-Frequency Transducer 36Hz ­ 20kHz 225W 110W/440W 91dB 8 Ohms 300Hz, 4000Hz Dual 8" (200mm) PolyPlas, shielded 4" (100mm) PolyPlas, TM shielded 3/4" (19mm) Titaniumlaminate dome, shielded, EOSTM waveguide 40-1/4" x 9-7/8" x 15-3/4" 1022mm x 251mm x 400mm 43. 5 lb/19. 8kg TM VOICE 70Hz ­ 20kHz 150W 75W/300W 90dB 8 Ohms 3500Hz Dual 5" (130mm) PolyPlas, shielded NA 3/4" (19mm) Titaniumlaminate dome, shielded, EOSTM waveguide 6-1/2" x 20-1/4" x 9-5/8" 165mm x 514mm x 244mm 9. 6 lb/4. 4kg TM BALCONY 65Hz ­ 20kHz 100W 50W/200W 86dB 8 Ohms 2000Hz 4" (100mm) PolyPlas, TM shielded NA 3/4" (19mm) Titaniumlaminate dome, shielded, EOSTM waveguide 10" x 10-1/8" x 6" 254mm x 257mm x 152mm 8 lb/3. 6kg Dimensions With Grille (H x W x D) Weight per Speaker All features and specifications are subject to change without notice. [. . . ]