User manual JBL BASS15

[. . . ] A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] The remote control will overide the trigger input. Power Trigger Outputs If you wish to have other components in your system turn on via trigger, make sure they are compatible with the 1/8" (3. 5mm) 12-volt DC Trigger Output Jack C on the JBL BassQ unit. If they are, you may connect the Trigger Output Jack C to the first component's trigger input using one of the cables included with the JBL Performance Series AVA7, and then connect all components in daisychain fashion. There are five trigger outputs on the rear panel of the JBL BassQ unit. · Pass-through sends the 12-volt trigger signal out in parallel to the input. Use this to trigger the AVA7 amplifier, or the first amplifier you are using in the system. · 2S sends the 12-volt signal 2 seconds after the input is received. · 4S sends the 12-volt signal 4 seconds after the input signal is received. · 6S sends the 12-volt signal 6 seconds after the input signal is received. · 8S sends the 12-volt signal 8 seconds after the input signal is received. Movie Trigger Input Using a 12-volt trigger from the Movie/ Music switching can be automated. Normal operation will resume when new batteries are installed. To replace the remote control batteries: 1. Locate the battery compartment on the back of the remote control. Pull down on the battery tray to slide out the old battery. The tray is held in place by a pressure-fit lock and requires a small amount of force to remove. Observing the proper polarity, insert one CR2032 battery. Slide the battery tray back into the remote until the tray locks into place. CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. If it will be stacked with other components, use the feet that came attached to the unit. This will ensure that there is sufficient space underneath so that heat can be dissipated effectively. Two rack ears are included with the JBL BassQ unit. To install these rack ears, remove the two machine screws on each of the two side panels (see drawing), hold each rack ear in place, and attach it to the unit using the same two screws. Make sure that these screws are securely tightened. [. . . ] If you have more than one subwoofer, it is best to place them an equal distance from the listening position. If this is not possible, use the distance from the closest subwoofer for the speaker distance settings. If using the AV2 Autocal, the distances will automatically be set. Be sure to set the AV2 to Yes for BassQ in the AV2 setup menu. [. . . ]