User manual JBL CM62 BLK

[. . . ] Servicing is required when the apparatus has been damaged in any way, such as: when the power supply cord or plug has become damaged, when liquid has been spilled or objects have fallen into the apparatus, when the apparatus has been exposed to rain or moisture, when the apparatus does not operate normally, or the apparatus has been dropped. Do not expose this apparatus to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the apparatus. To completely disconnect this apparatus from the AC mains, disconnect the power supply cord plug from the AC receptacle. The mains plug of the power supply cord shall remain readily operable. [. . . ] If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and then on, the user is encouraged to try to correct the interference by one or more of the following measures: · Increase the separation between the equipment and receiver. · Connect the equipment to a different outlet so that the equipment and receiver are on different branch circuits. · Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by JBL could void the user's authority to operate the equipment. iC statement and Warning This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. ImpoRtANt Note foR All electRoNIc pRoducts: Before inserting or unplugging audio cables from the source device's headphones or line-level output jacks, it is good practice to turn off the device first. This will prolong the life of your unit, help protect your device from static electricity and prevent potential damage. 2 JBl On stage®* MicrO iii easy setup guide 1. Carefully unpack your speaker dock and confirm that all the items shown here are included: JBL On Stage®* Micro III Speaker Dock, power supply, remote control and iPod/iPhone adapter. Notes on battery use: · If you are using rechargeable batteries, make sure all of them are fully charged before inserting them. The JBL On Stage Micro III will not charge rechargeable batteries. · If you are using conventional batteries, make sure that all of them are fresh. · Do not use a combination of rechargeable and conventional batteries. Place your iPod/iPhone on the JBL On Stage Micro III's docking connector. Make sure the iPod/iPhone is inserted all the way onto the connector. Use your computer's iTunes software to synchronize the iPod/ iPhone with iTunes. When you're finished synchronizing, eject the iPod/iPhone from iTunes. Operating yOur JBl On stage MicrO iii On Battery pOwer If you have inserted batteries as explained in the JBL On Stage Micro III Easy Setup Guide ­ Step 3, on page 3, you can unplug the JBL On Stage Micro III's power adapter and the unit will operate on battery power. While running on battery power, the JBL On Stage Micro III will automatically enter the Standby mode after the system detects no audio signal for 5 minutes. Upon detecting an audio signal the system will return to normal operation and the LED will light up. When running on AC power, the JBL On Stage Micro III will automatically enter the Standby mode after the system detects no audio signal for 10 minutes. As above, it will return to normal operation upon detecting an audio signal, and the LED will light up. Notes on battery power operation: · The JBL On Stage Micro III will not charge rechargeable batteries. · The JBL On Stage Micro III will not charge a docked iPod/iPhone while under battery power unless it is also connected to a computer via a USB cable. ipod/iphone charging The JBL On Stage Micro III will charge a docked iPod/iPhone under these conditions: · When the JBL On Stage Micro III is being powered by its AC power adapter · When the JBL On Stage Micro III is connected to a computer via a USB cable The JBL On Stage Micro III will not charge a docked iPod/iPhone while under battery power unless it is also connected to a computer via a USB cable. www. jbl. com 7 English trOuBleshOOting yOur JBl On stage MicrO iii trOuBleshOOting yOur JBl JBl On stage MicrO iii prOBleM No sound (white led is not illuminated): sOlutiOn · akesurethatthepowersupplyisproperlyconnectedtotheJBLOnStageMicroIII M and to a working AC outlet. ·fyou'reusingbatterypower, replaceallfourbatterieswithbrand-newdisposableor I freshly charged rechargeable batteries. [. . . ] U 8 prOBleM maximum volume level is reduced: sound comes from only one speaker: sOlutiOn · BLOnStageMicroIIIisinBatteryConservationMode(BCM). SwitchtoACpower J for higher performance. · akesurethattheiPod/iPhoneisproperlyseatedallthewayintothedocking M connector. · akesurethattheaudiocableispluggedallthewayintotheAudioInjack. M · akesurethattheaudiocableisastereocable. [. . . ]