User manual JBL CREATURE II

[. . . ] Do not expose the speaker system to temperature or humidity extremes, direct sunlight, excessive dust, or vibrations. Place the speaker system on a stable, level surface. Do not drop, apply excessive force to the controls, or put heavy objects on top of the speaker. If cleaning is required, use a soft dry cloth. [. . . ] Step 4 Plug the AC power supply jack into the subwoofer. Step 5 Plug the AC plug into the wall outlet. Step 6 Turn on the speaker set and adjust the volume accordingly. Placement of speakers The speakers are magnetically shielded and can be placed close to a computer monitor without distorting the image. For optimal stereo imaging, separate the speakers from each other by a distance equal to your distance from the speakers. The subwoofer's sound is non-directional; therefore, it does not have to be placed in any particular relationship to the satellites. The subwoofer is magnetically shielded and can be placed on the desktop, if desired. If the subwoofer is placed too close to a computer monitor it can cause vibration on the monitor screen. Document Number: 950-0045-001 Revision: A Harman Multimedia Confidential Description: MANUAL, CREATURE, ENGLISH Page 3 of 6 Using the speaker system On/Off Switch An on/off switch is located on the rear of the subwoofer. There is a green LED located on bottom of each of the two satellite speakers. There is also a green LED located on the bottom-back of the subwoofer. All three LEDs should illuminate when the system is connected correctly and receiving power. Turn the speaker off if it will not be used for a long period. Volume Control The volume control can be found on the front of the control/right satellite speaker. Touching the right + button on the front of this speaker will turn up the volume setting in increments of 2. 0 dB per step. If the button is continuously touched, after 0. 5 seconds the volume level will constantly increase at a rate of 5 dB per second. Touching the left - button on the front of the right speaker will turn down the volume setting in increments of 2. 0 dB per step. If the button is continuously touched, after 0. 5 seconds the volume level will constantly decrease at a rate of 5 dB per second until the system is muted. The JBL CREATURE will retain the volume setting when it is turned off so that when the speaker system is turned back on, it will restore the last volume setting. Muting Touching the left and right buttons simultaneously on the front of the right speaker will mute the audio. Power will remain on (both speakers' LED's remain illuminated). When muted, touching either the left button or the right button, or both buttons simultaneously will restore volume to the level prior to the activation of the mute function. Controls on the Subwoofer Bass - Turn the knob marked Bass clockwise to increase the subwoofer level or counterclockwise to decrease the subwoofer level. [. . . ] 5 inch Magnum woofer 9 watts per satellite at 10% THD 27 watts at 10% THD 180 Hz 3. 0 inches 9. 0 inches 3. 0 inches 9. 0 inches 3. 0 inches 10 inches 5-10kOhm >70dB 35 ­ 20 kHz 300-400 mV rms for rated power output 120 volts, 60Hz AC 120 watts Regulatory FCC Statement and Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]