User manual JBL CS 400 SATELLITE

[. . . ] It enables us to keep you posted on our latest advancements, and helps us to better understand our customers and build products that meet their needs and expectations. Left Front Channel Subwoofer Right Front Channel Center Channel Right Surround Channel Right Rear Channel INCLUDED Carefully unpack the system. If you suspect damage from transit, report it immediately to your dealer and/or delivery service. Keep the shipping carton and packing materials for future use. [. . . ] Attach the bracket to the wall using two screws (not included). Remove the rubber ring on the bottom of the satellite, and sit the satellite onto the back bracket. Attach 1/4-20 screw into insert on bottom of speaker and tighten. Step 5. Screw the ball and shaft assembly (B) to the 1/4"-20 insert on the back of the satellite (do not use the bottom insert on the speaker). Back out 1/2 of a turn and tighten the nut against the speaker. If the ball and shaft assembly is not backed out before tightening the nut, performing Step 8 below may dislodge the threaded insert in the speaker housing and permanently damage the speaker. Step 6. Drop round collar (C) over ball and shaft assembly (B) that is mounted to the speaker with the finished side of the collar facing the rear of the speaker. Carefully push the ball straight into the socket mounted on the wall, angle the speaker as desired and tighten the collar using the enclosed metal bar. Metal bar Adjustable Wall Bracket Step 1. Remove cap over threaded insert on rear of speaker Step 2. Mark the positions on the wall where you would like to place the mounting screws. Place bracket against the wall and fasten four 1-1/2" #10 wood screws through the bracket's screw holes into the wall. If a wall stud is not available, use an appropriate anchor. Bracket on wall. 4 CONNECTIONS After placing the speakers, you are ready to connect your system. Use high-quality speaker wire to make your connections; #18-gauge speaker wire with polarity coding is recommended. [. . . ] If the problem appears in the opposite speaker, the cause is in another component or cable. In the event that your speaker ever needs service, contact your local JBL dealer or distributor, or visit www. jbl. com for a service center near you. Figure 4. Wiring diagram shows polarity connections for one channel of a home theater system. 5 SPECIFICATIONS CS400SAT Frequency Range (­6dB): Recommended Amplifier Power Range: Sensitivity (2. 83V @ 1 meter) Nominal Impedance: Crossover Frequency: Midrange Driver: High-Frequency Driver: Dimensions (H x W x D): Weight: 110Hz ­ 20, 000Hz 10 ­ 100 Watts 86dB 8 3. 0kHz; 12dB/octave 3-1/2" (89mm) Magnetically shielded 1/2" (13mm) Titanium-laminate, magnetically shielded 6" x 6-3/8" x 3-7/8" (152mm x 162mm x 98mm) 2. 0 lb (0. 9kg) Features, specifications and appearance are subject to change without notice. INSTRUCTION SHEET (3/05) A. [. . . ]