User manual JBL ESC 400

[. . . ] Do not use liquid cleaners or aerosol cleaners. Do not use attachments not recommended by the product manufacturer as they may cause hazards. Do not use this product near water ­ for example, near a bathtub, wash bowl, kitchen sink or laundry tub; in a wet basement; or near a swimming pool; and the like. Do not place this product on an unstable cart, stand, tripod, bracket, or table. [. . . ] This product may be equipped with a polarized alternating-current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. Powersupply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. The power cord of the product should be unplugged from the outlet when left unused for long periods of time. If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. Front, rear and center speakers with rotating logo. Batteries. RED TAG 5' BLACK TAG 9' Subwoofer. WHITE TAG 28' { { FRONT { CENTER Cables. Wall-Mounting Your ESC200 Satellites The ESC200 Satellites may be wall-mounted. The customer is responsible for proper selection and use of mounting hardware available through hardware stores to properly and safely wall-mount the ESC200 Satellites. This product is not intended for ceiling mounting. { REAR { { one. Speaker Placement Front Center 0-2 ft. Place the center speaker even with the left and right speakers, or slightly behind. Place all three front speakers at approximately the same height. (Height of ears preferable. ) Rear Subwoofer 6" 6" 5 - 6 ft. Optimum subwoofer placement, positioned vertically or horizontally. Rotating logo. Pull out gently and turn. On optional stands. Speaker Connections To connect your speakers, press down on the quick release tab, which opens the terminal for the speaker wire, and put the wire in straight. Release the tab and give the speaker wire a gentle tug. If it's in properly, it won't "give" at all. Use the shortest wire for the CENTER speaker, the two medium length wires for the FRONT speakers, and the long wires for the REAR speakers. Always insert the RED coated wire into the RED terminal and the BLACK coated wire into the BLACK terminal on each of your speakers and the appropriate terminal on the back of the PROCESSOR. Back of Speaker Red Black Make sure you match RED to RED and BLACK to BLACK on both ends. F t Front Right Speaker ­ + Center Speaker Front Left Speaker ­ + ­ + SPEAKER IMPEDANCE: 8 ­ FRONT SPEAKERS RIGHT LEFT + ­ + ­ REAR SPEAKERS RIGHT LEFT + ­ + SUBWOOFER ­ + CENTER SPEAKER Subwoofer 3A ­ + FU SE LEFT RIGHT INPUT 1 LEFT RIGHT INPUT 2 LEFT RIGHT OUTPUT 1/2 three. [. . . ] · Check all connections between processor/amplifier and each of the speakers. If one or more of the speakers does not play, check the following: · Check all connections between processor/amplifier and each of the speakers. · Adjust the balance controls from left to right and front to rear. If you have very little bass output, check the following: · Make sure the subwoofer is connected properly to the processor/amplifier. [. . . ]