User manual JBL GTO507C

[. . . ] REAR DECK PRECAUTION In some cars, fuel tanks may be located directly beneath the rear deck. Before installation, make sure there is adequate speaker basket clearance before considering this location. ABOUT THE CONTENTS The Grand Touring Series component system includes: · Woofers · Grilles and mounting adapter(s) (no grille with the GTO8607C) · Tweeters with surface/flush I-MountTM (patent no. 5, 859, 917) kits · Crossover networks with mounting screws NOTE: The supplied crossover networks are designed to work with the above-listed transducers. [. . . ] · Do not mount speakers where they will get wet. · If possible, select a mounting site for the crossover network that is near the speakers and provides easy access for connections. INSTALLATION Figure 1. Mounting the woofer in a factory location without the grille (except GTO607C). Figure 2. (No grille is supplied with the GTO8607C. It is designed to be installed under the factory grille. ) 2 INSTALLATION INTERMOUNT III* MOUNTING RINGS The GTO607C is packaged with two different speaker adapters. The adapters will allow the speakers to be installed into various factory 6, " 6-1/2" and 6-3/4" openings. The metal adapter can be mounted in many European vehicles, Japanese vehicles or vehicles with 6" speaker locations. The plastic adapter can be mounted in many vehicles using 6-3/4" speaker locations or three-point mounting frames. Mounting the GTO607C using the supplied metal adapter. Mounting with the plastic adapter is similar. Mounting the tweeter using the I-Mount flush-mounting kit. 3 TWEETER ANGLE Figure 6. Aim the tweeter at the listening position by sliding the screw in the groove on the back of the tweeter cup and lock the tweeter in place using the small retaining screw. Rotate the entire assembly in the mounting surface and tighten the large hand nut. 3 ROTATE ENTIRE ASSEMBLY TO AIM ANGLED TWEETER TOWARD LISTENER. Figure 7A. Surface-mounted behind grille panel. 1 2 1 SLIDE BLACK (--)SCREW UP OR Figure 7B. Flush-mounted to surface behind grille panel. SURFACE-MOUNT (--) Figure 5B. Mounting the tweeter using the SMALL LUG BLACK I-Mount surface-mounting cup. 1 ATTACH BASE WITH SCREWS, THEN: DOWN TO ADJUST TWEETER ANGLE. 2 RED (+) BLACK (--) TIGHTEN SCREW TO LOCK ANGLE SETTINGS. 4 RED (+) RED (+) LARGE LUG 2 3 SECURELY TIGHTEN THE LARGE HAND NUT. Figure 7C. Mounted to grille panel. FOAM GASKET MOUNTING RING Figure 4. Mounting the GTO607C woofer without the metal adapter. Figures 7A through 7D. The StarfishTM tweeter mount is intended to be used when the tweeter will be installed behind a factory grille (e. g. , replacing the factory tweeter behind a door panel). The Starfish will allow you to mount the component tweeter directly to the panel itself or to the area behind the panel. [. . . ] Other woofers are wired similarly. J1 2 Ohms 2 Ohms 2-3/8" (61mm) 2-1/4" (58mm) 5-11/16" (145mm) 4-15/16" x 7-3/16" (126mm x 183mm) 6-9/16" (167mm) 5-11/16" (145mm) To WOOFER To AMPLIFIER OUTPUTS Big Lug = Small Lug = GENERAL CARE The loudspeaker grilles may be cleaned with a damp cloth. Do not use any cleaners or solvents on the grilles or the speaker cones. These products are designed for mobile applications and are not intended for connection to the mains. A valid serial number is required for warranty coverage. [. . . ]