User manual JBL GTX15

[. . . ] Do not substitute another crossover network or use other speakers when connecting the system (see Figures 8A and 8B). INSTALLATION TIPS · Always wear protective eyewear when using any tools. · Turn off all audio components and other electrical devices before you start. Disconnect the (­) negative lead from your vehicle's battery. [. . . ] · Keep speakers in their package until final installation. When moving a speaker, always rest it with the cone or dome facing up. · Check clearances on both sides of a planned mounting surface before drilling any holes or installing any screws. Remember that the screws can extend behind the surface. · At the installation sites, locate and make a note of all fuel lines, hydraulic brake lines, vacuum lines and electrical wiring. Use extreme caution when cutting or drilling in and around these areas. · Before drilling or cutting holes, use a utility knife to remove unwanted fabric or vinyl to keep material from snagging in a drill bit or saw. · For door installations, check the clearance with the windows throughout the range of the window's travel, and verify that a mounted speaker will not interfere with the window crank or power window mechanism. · If mounting speakers elsewhere, check for clearance around rear-deck torsion bars, glove box or other structural elements. · Do not mount speakers where they will get wet. The Starfish will allow you to mount the component tweeter directly to the panel itself or to the area behind the panel. The six mounting tabs can be removed easily to create a number of custom configurations. Note: Check screw clearance before installing. Note: Not all possible mounting configurations are shown. Figure 7D. In-dash location (may require gluing). FOAM GASKET * patent no. 6, 505, 705 3 CONNECTIONS Open the crossover housing by firmly squeezing the sides of the top half and lifting it away from the bottom. Using screws or a wire tie, mount the crossover using the holes provided. Observing proper polarity, connect the speakers and amplifier as shown in Figures 8A­8C. Replace the cover when you are finished making the connections and adjustments (see following section). Wiring connections on the crossover network (shown with cover on). To TWEETER SPECIFICATIONS Figure 8B. [. . . ] Wiring connections on the crossover network (shown with cover on). To TWEETER SPECIFICATIONS Figure 8B. The 0dB setting is the reference setting. Move the jumper to the +3dB setting if more tweeter output is required. Tweeter level 0dB (default) Tweeter level +3dB GTO507C 5" (130mm) Two-way component Power Handling 55W RMS, 165W Peak Sensitivity (2. 83V/1m) 91dB Frequency 70Hz ­ 21kHz Response Impedance 2 Ohms Mounting Depth 2-5/16" (59mm) Cutout Diameter 4-11/16" (120mm) Type Overall Diameter 5-1/8" (131mm) GTO607C 6-1/2" (160mm) Two-way component 70W RMS, 210W Peak 92dB 55Hz ­ 21kHz 2 Ohms 2-1/16" (53mm) 5-1/16" (129mm) 6-1/4" (159mm) GTO6507C 165mm Two-way component 70W RMS, 210W Peak 92dB 55Hz ­ 21kHz GTO8607C 6" x 8" (5" x 7") Two-way component 70W RMS, 210W Peak 92dB 55Hz ­ 21kHz GTX15 165mm Shallowmount two-way component 60W RMS, 180W Peak 92dB 55Hz ­ 21kHz 2 Ohms 1-13/16" (47mm) 5-11/16" (145mm) 6-9/16" (167mm) Figure 8C. Locating wiring connections on the GTO507C woofer. [. . . ]