User manual JBL ON TIME 200ID

[. . . ] JBL ON TIME 200ID TM AM/FM RADIO AND SPEAKER DOCK FOR iPod iPod not included/iPod non inclus USER GUIDE English. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Français . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Italiano . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44 Español . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press the Menu/Up Level button until you reach the Top Menu screen. Use Up/Down arrows to select Region and press Enter. Use Up/Down arrows to select radio band region type. Press Enter. Alarm Power Radio Tuning 1. If AM or FM radio is already selected and playing, use Up/Down arrows to tune frequency; hold either button and release to scan for the next station. Otherwise, press Source until FM or AM is selected. Tune to the desired frequency using Up/Down arrows; hold either button and release to scan for the next station. Source Preset Select Up Menu/Up Level Enter Setting Presets 1. While listening to AM/FM radio, press and hold Preset for 2 seconds. The Radio Preset screen will be displayed. Use Up/Down arrows to select slot to store preset. Preset is stored! Select Down To Select a Preset for Listening 1. Press Preset once at any screen to display the Preset list. Preset station will begin playing! WWW. JBL. COM 7 English CONTROLS (CONT. ) Alarm Setting 1. Press Menu/Up Level at any screen to display Top Menu (may require repeated presses, depending on which menu state the unit was previously in). Press Enter to confirm; or press Alarm to go directly to the Alarm menu. Use Up/Down arrows to select an Alarm slot to edit. Use Up/Down arrows to set Day of Week, Weekdays, Weekends, Everyday or One-Time. Alarm is set! Note: During alarm-setting, if there is no user input for 2 seconds, display will return to the Now Playing screen. Press any one of the Enter, Up/Down arrows, or Menu/Up Level to return to setting selection. Use this same procedure to modify a previously set Alarm. Alarm Power Source To Enable/Disable a Set Alarm 1. Press Menu/Up Level at any screen to display the Top Menu (may require repeated presses, depending on which menu state the unit was previously in). Press Enter to confirm; or press Alarm to go directly to the Alarm menu. [. . . ] Make sure the unit is connected to an appropriate source device. Make sure all signal cables are inserted snugly into receptacles. Check volume of source device; some devices will distort the output signal if the volume is set to maximum. We recommend that the source device EQ be set to Flat or Off. [. . . ]