User manual JBL JBL SA600 SERVICE MANUAL

[. . . ] · Triple chamber band-pass subwoofer. One pair of sat10 surround speakers with removable wall-mounting brackets. · Adjustable satellites with shelf stands included. [. . . ] · Recessed wire channels on satellites and surrounds. · Diffraction-limiting foam satellite baffles. one. Speaker Placement Satellites 0-2 ft. Subwoofer Surround Speakers 5 ­ 6 ft. Mounting Options Satellites On shelves. On the wall. SFX10BKT, or SFX10BKTWHT (white). On optional stands. FS10/20WHT (white). Surrounds On shelves. Wall-mounted. Brackets and hardware included. On optional stands. two. Speaker Connections Connection Tips For satellites, thread speaker wire through the hole in the bottom of the speaker, then feed it through the recessed wire channel. Separate and strip the ends of the speaker wire as shown. Speakers and electronics terminals have corresponding (+) and (­) terminals. It is important to connect both speakers identically: (+) on the speaker to (+) on the amplifier and (­) on the speaker to (­) on the amplifier. Make sure none of the speaker wires are frayed, cut, or punctured. If the system plays at low volumes but shuts off as volume is increased, check the following: · Check all wires and connections between receiver/ amplifier and speakers. · Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut, or punctured. · If more than one pair of main speakers is being used, check the minimum impedance requirements of your receiver/ amplifier. If there is low bass output, check the following: · Make sure the polarity (+ and ­) of the left and right "Speaker Inputs" are connected properly. If there is no sound from the surround speakers, check the following: · Check all wires and connections between receiver/ amplifier and speakers. · Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut, or punctured. [. . . ] Make sure none of the speaker wires are frayed, cut, or punctured. · Review proper operation of your receiver/amplifier and its surround sound features. Specifications SCS110 System Power Handling 10 ­ 120 watts Frequency Response 40Hz ­ 20kHz (±3dB) sat10 Power Handling 10 ­ 80 watts Frequency Response 150Hz ­ 20kHz (±3dB) Impedance 8 ohms nominal Sensitivity 88dB @ 1 watt/1 meter Crossover Frequency 3. 5kHz (midrange to tweeter) Tweeter One 3/4" titanium composite dome, video-shielded Midrange One 3-1/2" neodymium driver, video-shielded Dimensions (HxWxD) 6-1/2 x 3-3/4 x 4-1/4 inches 165 x 95 x 108mm Weight 1. 5 lbs/. 7 kg bass10 Power Handling 10 ­ 120 watts Frequency Response 40Hz ­ 150Hz (±3dB) Impedance 8 ohms nominal Sensitivity 88dB @ 1 watt/1 meter Crossover Frequency 150Hz (subwoofer to satellite) Bass Two 5-1/4" woofers Triple chamber band-pass subwoofer Dimensions (HxWxD) 14-3/4 x 8-1/2 x 19 inches 375 x 216 x 465mm Weight 28 lbs/12. 7 kg Accessories such as the optional stands and brackets are available through your JBL dealer. For a dealer in the USA call 1-800-336-4JBL. [. . . ]