User manual JBL MPS1000

[. . . ] NOTE: This marine product is not intended for automotive applications. INSTALLATION WARNINGS AND TIPS · Always wear protective eyewear when using tools. · Turn off the audio system and other electrical devices before you start. Disconnect the (­) negative lead from your boat's battery. [. . . ] · Install a fuse holder with a 30A fuse within 18" of the battery + terminal (see Figure 5). · The REM connection requires +5 to +12 Vdc signal for the MPS1000 to turn on. Most head units provide this remote voltage signal. Connecting the Signal The MPS1000 includes a 2-channel speaker-level input and a 2-channel line-level input. Either input connection type may be used. Follow the diagram below to connect signal to your MPS1000. Figure 3. Green: left out Gray: right out White: left in Red: right in Speaker-level inputs: Gray: right + Gray/black: right ­ White: left + White/black: left ­ Red to battery + Black to battery ­ Blue to remote turn-on from head unit MOUNTING THE MPS1000 CAUTION: Make sure mounting screws will not puncture wiring harnesses, control cables, hydraulic or fuel lines, the fuel tank or the hull. Some or all of these may be located behind or under the mounting surface. 2 CONTROLS AND FUNCTIONS The MPS1000 has several controls and indicators that simplify sonic integration with the rest of the speakers on your boat. To gain access to the controls, you must remove the cover and the water-tight rubber plug underneath. To remove the cover, remove the two small Phillips-head screws and pull the cover away, according to the arrow in Figure 4. To reinstall the cover, follow the arrows in Figure 6 and replace the two screws. MPS1000 controls on the front panel TUNING THE MPS1000 1. Make sure the head unit is off and its volume control is set to minimum. On the MPS1000's front panel, set the Gain control to the midpoint position. Set the Crossover control to its maximum position (clockwise). Set the Bass Boost control to the minimum position (counterclockwise). Turn on the head unit and play a favorite music track that has substantial bass. Set the head unit's volume control to 75% of the total output (approximately 3 o'clock on rotary controls). Listen to your system, making a mental note of the amount of upper bass being reproduced. Switch the Phase control to 180° and listen again for upper bass content. [. . . ] Readjust Gain control (see "Tuning the MPS1000" on the previous page). Readjust Bass Boost control (see "Tuning the MPS1000" on the previous page). Head-unit output is distorted or blown. 1-1/2" 39mm 7-15/16" 202mm A valid serial number is required for warranty coverage. Features, specifications and appearance are subject to change without notice. 9-3/16" 234mm 10-1/8" 258mm Declaration of Conformity Harman Consumer Group, Inc. [. . . ]