User manual JBL OT-200ID

[. . . ] Indd 1 04/09/08 16:26:49 IMPORTANT SAFETY INSTRUCTIONS PLEASE READ THE FOLLOWING PRECAUTIONS BEFORE USE: • • • • • • • • • • • • • • • • • • • Read these instructions, heed all warnings and keep for future reference. Do not block any ventilation openings; a minimum distance of 10mm around the entire apparatus is required for sufficient ventilation. No naked flame sources, such as lighted candles, should be placed on or near the apparatus. Attention should be drawn to the environmental aspects of battery disposal. [. . . ] Note: During clock-setting, if there is no user input for 2 seconds, display will return to the Now Playing screen. Press any one of the Enter, Up/Down arrows, or Menu/Up Level to return to setting selection. Press the Menu/Up Level button until you reach the Top Menu screen. If AM or FM radio is already selected and playing, use Up/Down arrows to tune frequency; hold either button and release to scan for the next station. Otherwise, press Source until FM or AM is selected. Tune to the desired frequency using Up/Down arrows; hold either button and release to scan for the next station. source Preset Select Up Menu/Up Level Enter Setting Presets 1. While listening to AM/FM radio, press and hold Preset for 2 seconds. Press Preset once at any screen to display the Preset list. Press Menu/Up Level at any screen to display Top Menu (may require repeated presses, depending on which menu state the unit was previously in). Note: During alarm-setting, if there is no user input for 2 seconds, display will return to the Now Playing screen. Press any one of the Enter, Up/Down arrows, or Menu/Up Level to return to setting selection. Press Menu/Up Level at any screen to display the Top Menu (may require repeated presses, depending on which menu state the unit was previously in). An icon will be displayed on the left when the alarm is enabled, and the alarm will sound at the set time. Use the steps under Alarm Setting and choose “iPod” as the source. On your iPod, choose the song you would like to awaken to and press Play. Set the volume level on the JBL On Time™ 200ID unit. Put your iPod to sleep by holding down the Play/Pause button (older iPod models may vary). The JBL On Time 200ID system can be put to sleep by pressing the Power button. Select Down Note: If you choose the last song on your iPod, please place the iPod in repeat mode, which will ensure that the iPod will continue playing past the last song. Press the Menu/Up Level button until you reach the Top Menu screen. Note: To set brightness to Auto, press the Down arrow until Auto is highlighted. [. . . ] If you have installed three AAA batteries, replace them, as they may be defective. Note JBL On Time 200ID unit does not retain memory settings when there is a power outage, or if the unit is unplugged There are no batteries installed in the unit Batteries may be low 14 JBL ON TIME 200ID USER GUIDE 0024CSK - JBLOnTime200iD v12. Make sure you do not have the JBL On Time 200ID unit connected to a USB hub; connect the unit directly into the computer’s USB port. Tryk Enter for at bekræfte eller tryk Alarm for at gå direkte til Alarmmenu. [. . . ]