User manual JBL R103

[. . . ] If you are not sure of the type of power supply to your home, consult your product dealer or local power company. For products intended to operate from battery power, or other sources, refer to the operating instructions. This product may be equipped with a polarized alternatingcurrent-line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. [. . . ] The product has been exposed to rain or water; or d. The product does not operate normally when following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation; or e. The product has been dropped or damaged in any way; or f. The product exhibits a distinct change in performance; this indicates a need for service. When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. The product should be mounted to a wall or ceiling only as recommended by the manufacturer. The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including amplifiers) that produce heat. THANK YOU FOR CHOOSING JBL For more than 50 years, JBL has been involved in every aspect of music and film recording and reproduction, from live performances to the recordings you play in your home, car or office. We're confident that the JBL loudspeakers you have chosen will provide every note of enjoyment that you expected ­ and that when you think about purchasing additional audio equipment for your home, car or office, you will once again choose JBL. The . 1 LFE channel contains additional low-frequency information not found in the left- and right-front channels. The LFE input works with the full-range speaker-level input to provide the dynamics and effects that your favorite filmmakers intended. You will need to use a Y-Connector (not included) with one male connector and two female connectors to connect the line-level subwoofer output on your receiver/amplifier to the LFE/Subwoofer inputs on the R103 speakers. Plug the male connector into the subwoofer output on your receiver or amplifier, and connect each of the two female connectors to RIGHT R103 extension RCA patch cords. Then plug each patch cord into the LFE/Subwoofer input of the left and right R103 speakers. Note: If your receiver has separate left and right line-level subwoofer (or LFE) output jacks, you do not need to use a Y-Connector. 5 AMPLIFIER CONTROLS LFE Level Control: Allows you to adjust the volume of the low-frequency effects/ subwoofer channel to suit your room acoustics or tastes. However, it only affects the LFE signal. If you are not using the LFE input, the LFE level control will not operate. Configuring Your Receiver: You should choose the "Large" or "Wide" option for the left- and right-front speakers so that full lowfrequency information will be sent to the R103 speakers. Make sure that you also configure your receiver for "Subwoofer On" or "LFE On. " In this case, the LFE/Subwoofer signal will consist only of the . 1 (bass) channel. The LFE signal level can be adjusted by using the LFE level on the R103 amplifier panel. [. . . ] If the problem is in the same place, the source of the problem is most likely with your receiver or amplifier, and you should consult the owner's manual for that product for further information. If the problem has followed the speaker, consult your dealer for further assistance or, if that is not possible, visit our Web site at www. jbl. com for further information. If the system plays at low volumes but shuts off as volume is increased: · Check all wires and connections between receiver/ amplifier and speakers. · Make sure all wires are connected. [. . . ]