User manual JBL RADIAL

[. . . ] Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Never remove grille covers in order to service the speaker system. [. . . ] The JBL Radial will provide astonishing bass and clear accurate sound from any direction. Halo acousticsTM - The horizontal acoustic level optimization or Halo acoustics design provides a full, rich sound field from any direction. The dual left and right tweeters and down-firing low transducer provides a 360 degree sound field. HerculesTM and OdysseyTM Transducers ­ The two full range transducers are driven by powerful Neodymium magnets. The Odyssey tweeters provide accurate high frequencies and Hercules provides a ful, rich frequency response from the lowest bass to the highest vocal range. COE (Computer Optimized Equalization) The JBL Radial system equalization is computer optimized to provide a rich, complete sound stage. OCT (Optimized Compression Topology) The JBL Radial utilizes a proprietary compression technology to ensure clean accurate sound at high output levels. Unpacking Carefully unpack your speaker system and identify all components: A) JBL Radial unit B) Power Supply C) Auxiliary audio cable D) USB cable E) Remote General Setup 1) Unpack the JBL Radial and power supply 2) Place your iPod adapter (included with iPod) into docking station 3) Place the iPod into the adaptor 4) Plug power adaptor into jack marked 24Vdc in 5) Plug adaptor into wall outlet 6) If an additional audio source is used, connect source into Aux In 7) If the use of S-Video out to a TV or monitor is desired, connect with S-Video cable 8) Connect the JBL Radial to a computer with the supplied USB cable for sync and charge functions 9) Install supplied coincell batteries into remote Listening to music from an iPod: First locate and place the appropriate corresponding universal iPod adaptor, included with iPod, into JBL Radial iPod docking location, then connect your iPod. b) Press the "Power" button on the rear of JBL Radial. A blue LED will indicate that the unit is on. C) Select and play music through your iPod controls or send commands to your iPod with the JBL Remote. ( Refer to JBL Remote user's guide for more information on the remote) D) Adjust volume using the "+" and "-" buttons located on the front of JBL Radial. Listening to music from an auxiliary device: The JBL Radial includes a 3. 5mm minijack cable for connection to any analog music player with a 3. A blue LED will indicate that the unit is on. C) Control music playback through the auxiliary device D) Adjust volume using the "+" and "-" buttons located on the front of JBL Radial. [. . . ] Ensure correct adaptor is used for your specific iPod model. ensure iPod is seated securely into the docking station. Make sure you do not have the JBL Radial connected to a USB or firewire hub. [. . . ]