User manual JBL REFERENCE 610

[. . . ] Please read the following precautions before use: Read these instructions, heed all warnings, and keep for future reference. Do not block any ventilation openings; a minimum distance of 10mm around the entire apparatus is required for sufficient ventilation. No naked flame sources such as lighted candles should be placed on or near apparatus. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatuses (including amplifiers) that produce heat. [. . . ] Make sure headphone power is "Off" and transceiver is disconnected from the iPod. Turn headphone power back "On" and wait for solid LED, then three quick flashes ­ indicating that the headphone system is in "discoverable" mode. To pair your Bluetooth-enabled device to the headphones, please refer to your user's manual for the proper setup procedure. When your audio device requests a passcode to pair with the JBL Reference Series 610 headphone system, enter the numerical sequence "0000". Note: The headphone control features may be limited when used with devices other than your iPod, due to the varying designs and possible remote control limitations of your audio device. The volume "_" and "+" buttons are controlled by pressing to make your selection. repeated pressing will reduce or increase volume , as desired. If you do not notice a change in the volume, make sure your iPod does not have a low battery. Located on the four-position toggle switch are: _( ) "menu" (push once to take you to menu mode) _ (<<) "previous track" (push once), "fast rewind" (press and hold) _ (>>) "next track" (push once), "fast forward" (push and hold) _ (>) "play/pause" (press once to play, once to pause) For situations when you are not able to use your Bluetooth wireless mode to stream music, the JBL Reference Series 610 headphones can be connected to your audio device through the included audio cable. Make sure the volume on your audio device is turned to the minimum position, to ensure hearing safety, prior to connecting your headphones. Turn the power "Off" on your headphones. Plug the mini USB connector on your audio cable into the headphone charging port. The control features buttons will not be functional when the headphone system is used with the audio cable. Menu mode brings up a second tier of iPod navigation features, which let you roam through your iPod menus. Push menu button ( ) once to take you to the menu mode. To scroll "up" (<<) or "down" (>>) the menu, hold down the proper feature button until you reach your selection. To make a selection from the menu list, push and hold the menu button ( ). In the menu mode, pressing and holding play/pause ">" allows you to turn your iPod on or off remotely from your headphones. Symptom when used with Bluetooth transceiver Possible Problem Solution Note Symptom when used with Bluetooth transceiver Headphone controls have intermittent operation. possible Problem Bluetooth transceiver is not connected properly. Bluetooth does not have good transmission through metal or water. If blue LED on headphones continues to blink rapidly after headphone system has paired, it is indicating a low battery. [. . . ] If you wish to re-pair, please follow initial pairing instruction. Headphone controls do not work Audio device is not compatible with Bluetooth audio device. Audio device does not recognize some control features. Because of the large variation in design, the control features may be limited due to restrictions on your audio device. [. . . ]