User manual JBL S CENTER II

[. . . ] S P E C I F I C AT I O N S Description: Maximum Recommended Amplifier Power:** Nominal Impedance: Sensitivity (2. 83V/1m): Frequency Response (­3dB): Crossover Frequencies: High-Frequency Transducer: 3-Way dual 5-1/4" center 150W 8 Ohms 91dB 75Hz ­ 20kHz 800Hz, 3200Hz 1" Pure-titanium dome, with rubber surround, shielded; Elliptical Oblate SpheroidalTM (EOS) waveguide 4" PolyPlasTM (polymer-coated cellulose fiber) cone, rubber surround, shielded; Linear Field ProximityTM (LFP) bezel 5-1/4" PolyPlasTM (polymer-coated cellulose fiber) cone, rubber surround, SFGTM magnetic shorting , rings, high-temp oversized Kapton® voice coil, HeatScapeTM motor structure, cast-aluminum baskets, shielded Low Diffraction, IsoPowerTM FreeFlowTM flared Straight-Line Signal PathTM (SSP) All-metal, gold-plated, 5-way binding posts 7-7/8" x 20-1/2" x 9" 200mm x 521mm x 229mm 15 lb/6. 8kg Midrange Transducer: Low-Frequency Transducer: Baffles: Port: Network: Terminals: Dimensions (H x W x D): Weight: * Dolby and Pro Logic are trademarks of Dolby Laboratories. DTS is a registered trademark of Digital Theater Systems, Inc. [. . . ] Use these placement recommendations as a guide. Slight variations will not diminish your listening pleasure. The Studio Series S-CENTERII loudspeaker is videoshielded and can safely be placed near a television. 0-2 ft. The S-CENTERII is designed to complement all of the Studio Series loudspeakers. It is the ideal way to re-create the cinematic experience in your home. The supplied self-adhesive felt pads may be attached to the bottom corners of your S-CENTERII speaker to protect your television or furniture. SPEAKER CONNECTIONS CONNECTION TIPS Speakers and electronics terminals have corresponding (+) and (­) terminals. It is important to connect both speakers identically: (+) on the speaker to (+) on the amplifier and (­) on the speaker to (­) on the amplifier. Wiring "out of phase" results in thin sound, weak bass and a poor stereo image. With the advent of multichannel surround sound systems, connecting all of the speakers in your system with the correct polarity remains equally important in order to preserve the proper ambience and directionality of the program material. To use the binding-post speaker terminals, unscrew the collar until the passthrough hole in the center post is visible under the collar. Insert the bare end of the wire through this hole; then screw the collar down until the connection is tight. [. . . ] · If your receiver/processor is set in Dolby Digital or DTS® mode, make sure the receiver/processor is configured so that the center speaker is enabled. We, Harman Consumer International 2, route de Tours 72500 Chateau-du-Loir France declare in own responsibility, that the loudspeaker described in this owner's manual is in compliance with technical standards: EN 50081-1:1992 EN 50082-1:1997 Luc E. Godard Harman Consumer International Chateau-du-Loir, France. [. . . ]