User manual JBL S36 AW

[. . . ] JBL is a registered trademark of JBL, Incorporated. ai0449 S36AW D E S I G N G O A L : Bring the thrill of live performance and movie sound to the outdoors by calling on JBL's professional engineering leadership. T W E E T E R T Y P E : Pure-titanium dome with EOSTM waveguide W O O F E R T Y P E : Cast-aluminum basket with HeatScapeTM motor structure C R O S S O V E R N E T W O R K : Straight-Line Signal PathTM (SSP) E N C L O S U R E D E S I G N : Sealed P R O F E S S I O N A L R E F E R E N C E : Studio Monitor THANK YOU FOR CHOOSING JBL For more than 50 years, JBL has been involved in every aspect of music and film recording and reproduction, from live performances to the recordings you play in your home, car or office. [. . . ] If the speakers will be above ear level, the tweeter array should be positioned down, preferably no more than two feet above ear level. If the speakers will be mounted very low, it may be best to position the tweeter array upward so that it will be no more than two feet below ear level. The S36AW enclosures are specially designed to angle the speakers toward the listener when mounted flush against the wall. When mounting the speakers outdoors, we recommend that you place them under an overhang, such as roof eaves, for added protection, and that you use two of the supplied special angle-mount screws per speaker, which angle the speakers downward at a greater-than-usual angle, facilitating water drainage. NOTE: When using the enclosed angle-mount screws, always use the top two screw locations appropriate for the specific mounting orientation of your S36AW. Referring to the enclosed installation template, screw locations (1) and (2) are to be used when mounting the S36AW horizontally so that these locations are on top. To mount the loudspeakers vertically, use locations (2) and (4) or locations (1) and (3), depending on the mounting orientation. Do not mount the S36AW upside down (with screw locations (3) and (4) on top) because it won't be able to lock onto the screw heads. Remember that the JBL logo on the tweeter/mid faceplate can be rotated with choice of speaker position (vertical or horizontal). At least one screw per speaker should be installed in a wooden wall stud. Select an appropriate wall anchor for the other screw. If the special angle-mount screws are not being used, size 10 screws of at least 1-1/2" in length are recommended. If the screws are used in drywall or other surfaces incapable of holding the screw by itself, selection of proper anchors is essential. The customer is solely responsible for proper selection and installation of screws, anchors and other installation hardware. [. . . ] If there is no sound coming from one speaker: · Check the "Balance" control on your receiver/ amplifier. · Check all wires and connections between receiver/amplifier and speakers. · Make sure all wires are connected. [. . . ]