User manual JBL SAT 1

[. . . ] Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand, tripod, bracket, or table recommended by the manufacturer, or sold with the product. Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer. [. . . ] This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company. For products intended to operate from battery power, or other sources, refer to the operating instructions. This product may be equipped with a polarized alternating-current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. Powersupply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. SFX20BKT, or SFX20BKTWHT (white). On optional stands. FS10/20WHT (white). Surrounds On shelves. Wall-mounted. Brackets and hardware included. On optional stands. two. Speaker Connections Connection Tips For satellites, thread speaker wire through the hole in the bottom of the speaker, then feed it through the recessed wire channel. Separate and strip the ends of the speaker wire as shown. Speakers and electronics terminals have corresponding (+) and (­) terminals. It is important to connect both speakers identically: (+) on the speaker to (+) on the amplifier and (­) on the speaker to (­) on the amplifier. Wiring "out of phase" results in thin sound, weak bass and a poor stereo image. Speaker level Left Front sat20 + ­ Subwoofer + ­ ­ + Center Speaker + ­ Right Front sat20 + ­ Left Right Output to Satellite Input from Amplifier Left Right + ­ ­ + Receiver Left Front + ­ Center + ­ Right Front ­ + Left Surround + ­ Left Surround + ­ Right Surround ­ + Right Surround + ­ Line level Left Front sat20 + ­ Subwoofer Input R L Center Speaker + ­ Right Front sat20 + ­ Receiver Front Left + ­ Rear Left + ­ Subwoofer Out R L Front Right ­ + Center + ­ Rear Right ­ + Note: Some receivers/ amplifiers have a single (mono) subwoofer output. In this case, it is recommended that you use a "Y"-connector (not included) to maximize the subwoofer's performance. Left Surround + ­ Right Surround + ­ three. Operation Power ON AUTO OFF POWER ON Typical Receiver AUTO OFF ON AUTO OFF Volume Level Level Troubleshooting If there is no sound from any of the speakers, check the following: · Receiver/amplifier is on and a source is playing. · Powered subwoofer is plugged in and is either in the "On" or "Auto" position. · Check all wires and connections between receiver/ amplifier and speakers. [. . . ] If the system plays at low volumes but shuts off as volume is increased, check the following: · Check all wires and connections between receiver/ amplifier and speakers. Make sure none of the speaker wires are frayed, cut, or punctured. · If more than one pair of main speakers is being used, check the minimum impedance requirements of your receiver/amplifier. If there is low bass output, check the following: · Make sure the connections to the left and right "Speaker Inputs" have the correct polarity (+ and ­). [. . . ]