User manual JBL SYN-K2

[. . . ] The apparatus is to be used in moderate climates only. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatuses (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched, particularly at the plugs and convenience receptacles, and at the point where they exit from the apparatus. Only use attachments/accessories specified by the manufacturer. [. . . ] 4 JBL ON TIME 200ID USER GUIDE 0024CSK - JBLOnTime200iD v12. Indd 4 04/09/08 16:26:51 UNPACKING YOUR JBL ON TIME™ 200ID Carefully unpack your speaker system and identify all its components: IR remote FM antenna JBL On Time™ 200ID Adapters for iPod Power supply Audio cable AM antenna QUICK SETUP INSTRUCTIONS • • • • • • Choose the appropriate adapter for iPod and place it into the docking station. For backup memory, install three AAA batteries in the battery compartment underneath the unit. Connect the external AM antenna for better reception. Unwind the FM antenna and straighten the wire for the best reception. Plug the power adapter into the “DC In” jack and then plug the adapter into a wall outlet. If an additional audio source is used, connect the source to the “Aux In” jack. Press Menu/Up Level at any screen to display Top Menu (may require repeated presses, depending on which menu state the unit was previously in). Note: During clock-setting, if there is no user input for 2 seconds, display will return to the Now Playing screen. Press any one of the Enter, Up/Down arrows, or Menu/Up Level to return to setting selection. Press the Menu/Up Level button until you reach the Top Menu screen. Snooze feature will use this value the next time it is activated. A single press brings up the preset screen from any menu. Repeated presses cycle through the preset list to the next preset slot. Press and hold for 2 seconds when listening to the radio and the Now Playing screen is displayed, to store current radio station. Increases volume level, turns Amps on if off, then increases volume. If not in snooze mode and Amps are on, displays changes to Volume screen and decreases volume level. Moves highlighted box up on any JBL On Time 200ID menu setting screen. Moves highlighted box down on any menu setting screen. Hold for 2 seconds to return to Now Playing screen. Press and hold for 2 seconds to enter Snooze Timer setting screen. A single press starts sleep time countdown, using currently set timer. [. . . ] Make sure all signal cables are inserted snugly into receptacles. Check volume of source device; some devices will distort the output signal if the volume is set to maximum. Wrap up excess input cable to make it as short as possible. Purchase a ferrite clamp and attach it over the input cable; a clamp can be purchased at your local electronics store. [. . . ]