User manual JBL UREI 1122

[. . . ] If necessary, use a damp cloth without any solvents. In order to protect the speaker system, avoid microphone feedback, continuous output from electronic musical instruments, or distorted output from any signal source. Do not place the speakers close to fluorescent light sources, or neon light fixtures. Although the speakers are magnetically shielded, keep magnetic storage media (disks and tapes) at least four inches from the speaker system in order to avoid data loss. [. . . ] The same approach of providing solid bass from a small enclosure guided the development of these Magnum transducers. As described in the Using the speaker system section of the user's guide, the bottom left and right corners of the control/right speaker feature - and + buttons. Briefly touching the appropriate button will cause a small step increase or decrease in the system volume. Touching the appropriate button for more than 0. 5 seconds will cause the volume to increase or decrease rapidly while that button is touched. Treble, Bass level adjust knobs are located on front of the subwoofer unit. A system on/off switch is also provided on the rear of the subwoofer unit. The system includes two desktop speakers and a subwoofer that can be placed either on the floor or on your desk. Both satellite speakers and the subwoofer are magnetically shielded to provide the greatest protection against computer monitor image distortion. Setup Carefully unpack your speaker system and identify all components: · · · · · A Control/Right Satellite speaker B Auxiliary/Left Satellite speaker C Subwoofer D Power Supply E Audio input cable Connect the speaker system as shown in the Connecting the speaker system to sound card illustrations. Once the speaker system is properly connected, turn on the power switch located on the rear of the subwoofer. Document Number: 950-0045-001 Revision: A Harman Multimedia Confidential Description: MANUAL, CREATURE, ENGLISH Page 2 of 6 Step 1 Connecting the speaker system to the computer: · If you have an integrated sound solution or a stereo sound card; connect the green connector from the subwoofer into the green jack on the computer. · If you have a multi-channel sound card; connect the green connector from the subwoofer into the green jack on the computer. · If you have a portable computer; connect the green connector from the subwoofer into the headphone jack on the computer. Make sure all switches for outlet/power strip are on and that all switches for speaker system are on. Ensure that the control speaker connector is pushed in properly. Remove the control /right speaker connector from the subwoofer, then reconnect this cable ensuring that the connector is pushed in properly. Turn monitor off to see if noise is eliminated. Move speaker cables farther away from monitor. Ensure that speaker is connected to the appropriate receptacle. Check color-coding on connectors when making connections. Make sure that all signal cables are inserted snugly into receptacles. Check volume of sound card via Windows Volume Control. Check speakers with another audio source. If the sub's led is not on, power is not getting to your speaker system. [. . . ] Speaker system experiences radio frequency interference or picks up a radio station Set each of the two knobs (treble, bass level) on front of the subwoofer back the their center /nominal positions. Turn Bass/Treble down or return their settings to the center position. Check input cable connection Wrap up excess input cable in order to make as short as possible Purchase a ferrite clamp and attach over input cable. A clamp can be purchased at your local electronics store Document Number: 950-0045-001 Revision: A Harman Multimedia Confidential Description: MANUAL, CREATURE, ENGLISH Page 5 of 6 SPECIFICATIONS Manufacturer Model Drivers (satellite) Drivers (subwoofer) Power (satellite) Power (subwoofer) Crossover Frequency (subwoofer) Dimensions Width: Satellite Subwoofer Depth: Satellite Subwoofer Height: Satellite Subwoofer Input Impedance Signal-to-Noise ratio Frequency Response Input Sensitivity USA/Canada Power Maximum Power Consumption UL/CUL/CE Approved Harman International Creature Odyssey Plus One 4. [. . . ]