User manual JBL WEM-1 (120V)

[. . . ] JBL® ON AIR WEM1 OWNER'S GUIDE IMPORTANT SAFETY INSTRUCTIONS 1. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] Make sure the antennas 4E are extended upward. Make sure the ID Code setting on the transmitter 6 is set to the same setting as that on the receiver B. See page 5 for more information on ID codes. If necessary, configure your receiver to activate the preamp level outputs for the main/front channels (consult your source's owner's manual for specific instructions). When connected properly, the LED on the front of the receiver should be red when first plugged in. When a button on the remote is pressed, the LED should flash green until the transmitter and receiver "lock in. " It will then also light in solid green. This LED will light in orange if the local input on the receiver is selected (see page 5 under "Local Input" for more details). Connection Option B Connecting using the speaker-level outputs from your receiver: NOTE: Make sure power is turned off on all components. Connect the speaker wire to the receiver's speaker outputs and the inputs on the transmitter module 8, as shown in Figure 3. Receiver Figure 1. Step 2. Place the receiver module in the desired location in your home near an AC outlet, as it needs to plug into the wall. Connect speaker wire (not included) to the push terminals on the receiver module A and to the connectors on your speakers, as shown in Figure 2. Please note that speaker wire features some form of a polarity indicator to help distinguish its two conductors. Use this polarity indicator to ensure that you are connecting the positive (+) terminal on one speaker to the positive (+) terminal on the other, and the negative (­) to the negative (­). Figure 3. Step 2. Place the receiver module in the desired location in your home near an AC outlet, as it needs to plug into the wall. 4 Step 3. Connect the speaker wire to the push terminals on the receiver module A and the terminals on the rear of your speakers, as shown in Figure 4. Please note that the speaker wire features a polarity indicator to help distinguish its two conductors. Use this polarity indicator to ensure that you are connecting the positive (+) terminal on one speaker to the positive (+) terminal on the other, and the negative (­) to the negative (­). Right Speaker Left Speaker When using the WEM-1 to power surround speakers in a home theater system: In this application, the output level of your WEM-1 will not only be dependent on the volume setting of your A/V source; it will also need to be properly adjusted after installation and before use in order to be able to work correctly with the other speakers in your multichannel surround system. To adjust the output level, turn your A/V source on, set your A/V source's volume control about a third of the way up, and activate the speaker-level-adjustment test tone. Make sure that the WEM-1 transmitter and receiver are on, both of the speakers are connected, and there is RF lock (i. e. , the LED on the receiver is solid green). Using the remote control 1 and 2, adjust the volume level of the WEM-1 until its output level is balanced with the rest of the speakers in your surround system. From this point on, you will not be using the WEM-1 remote control for volume settings. You will be increasing and decreasing the output level for the entire surround sound system using your A/V source's volume control. [. . . ] Please consult your JBL dealer or distributor, or visit www. jbl. com, for further information or assistance. Step 2. Attach the wall bracket to the left and right side, as shown in Figure 7. Reattach the four screws removed in Step 1 through the brackets into the receiver module, as shown in Figure 7. Wall-Mounting Adjustable wall brackets are included for the transmitter and receiver modules. The included brackets are for wall-mounting only; they are not to be used for ceiling-mounting. [. . . ]