User manual JBSYSTEMS LIGHT COLOR BALL V 1.0

[. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. [. . . ] CAUTION: To reduce the risk of electric shock, do not remove the top cover. FIXING HOLES DOME: The dome starts turning once the power cable is connected to the mains. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol determines: the minimum distance from lighted objects. The minimum distance between lightoutput and the illuminated surface must be more than 1 meters. To protect the environment, please try to recycle the packing material as much as possible. A new light effect sometimes causes some unwanted smoke and/or smell. This is normal and disappears after some minutes. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. In case of replacement of the lamp or maintenance, do not open the fixture within 15 minutes until the unit cools down after switching off. Always unplug the unit before servicing!Always use the same type of spare parts (bulbs, fuses, etc. ) When replacing parts, please only genuine spare parts. Unplug the mains cable to switch off the unit Wait for about 15 minutes until the unit has been cooled down. use a screwdriver to unscrew the 3 screws of the dome. ( A on the drawing ) On the inside of the dome you will see the lamp socket Unplug the old lamp. Hold the lamp socket while unplugging the lamp Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Never install lamps with a higher wattage! [. . . ] Once connected to the mains the device starts running. Regular breaks during operation are essential to maximize the life of this device as it is not designed for continual use. Do not switch the unit on and off in short time intervals as this reduces the lamp life. the units' surface temperature may reach up to 85°C. [. . . ]