User manual JBSYSTEMS LIGHT MIX 5.2 V1.0

[. . . ] To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. Don't place metal objects or spill liquid inside the unit. No objects filled with liquids, such as vases, shall be placed on this appliance. [. . . ] The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. The socket inlet shall remain operable for disconnection from the mains. The power cord should always be in perfect condition. Switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Never let the power-cord come into contact with other cables!In order to avoid a hazard, the unit shall only be used with the AC-adaptor delivered with it. If the ACadaptor is damaged, a same model adaptor shall be used only. When the power switch is in OFF position, this unit is not completely disconnected from the mains!In order to prevent electric shock, do not open the cover. In this manual we talk about "line inputs". This is a global name for inputs with a level between 750mV and 2V. FADER CONTROL: When connected to these inputs, compatible CD-players can be controlled by the fader starts of this mixer. POWER CONNECTOR: Plug in power adapter here and check the voltage level to match your country's standard. PHONO/LINE SWITCH: This switch makes it possible to switch between the Line and Phono level for these inputs. PHONO / LINE INPUTS: each used to connect two different audio signal levels. refer to switch (16) to change one line input to phono level. LINE INPUTS: Unbalanced RCA jacks for connecting stereo audio from line level sources such as CD players, Hi-fi VCR's, cassette and reel-to-reel tape decks, DAT machines, tuners, even synthesizers or other mixing consoles. RECORD OUTPUT: Carries the same signal as the master outputs but is not influenced by the master level control. HIGH AND LOW EQ: Adjusts the high and low frequency levels of the input channels for a good sound. iNPUT FADER: Controls individual source levels (channels) in the mix. [. . . ] With this switch you can turn the fader start control on and off 1. These fader starts are compatible with all current JB Systems CD-players. CROSSFADER IN LEFT POSITION: CD-player connected to fader start connector A is playing, the other CD-player is paused. CROSSFADER MOVES TO THE RIGHT: CD-player connected to fader start connector A stops playing, returns to its previously programmed cue point and waits in pause. [. . . ]