Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual JBSYSTEMS LIGHT RS-218B. We hope that this JBSYSTEMS LIGHT RS-218B user guide will be useful to you.
Lastmanuals help download the user guide JBSYSTEMS LIGHT RS-218B.
Manual abstract: user guide JBSYSTEMS LIGHT RS-218BV1.1
Detailed instructions for use are in the User's Guide.
[. . . ] Just unscrew the 2 small bolts (marked "C" on the picture) so you can remove the cap and change the switch position. You can put the switch in 2 different modes (also see the electronic diagram of the switch) : Congratulations and thank you for buying this SYNQ product. Please read these operating instructions carefully so you will know how to operate this product properly. [. . . ] IMPORTANT: Both inputs must be connected and the amplifier must be set to MONO mode (NOT Bridge!) ® Both woofers inside the cabinet have their own Speakon input connector. This means that you can connect the left output of an amplifier to the left input of the subwoofer and the other amplifier output to ® the right Speakon input. the power needed at the inputs is 2x 600Wrms @ 8ohm. (2x 1200Wpeak) B) Woofers in parallel: Used when you have powerful amplifiers that can deliver the high power needed by the subwoofer. If you like, you can connect a second RS218B in parallel. Attention: when a second subwoofer is connected, the impedance drops from 4 to 2!Please note that most amplifiers do not support heavy working conditions while under 2 load. moreover the damping factor of your amplifier drops significantly resulting in a weaker bass response. Preferred setup combination: When used with the RS-15 cabinets you should try to keep a certain balance with this subwoofer to make a good sounding system. we suggest using 2pcs RS-15 on 1pc RS-218B. You should always use separate amplifiers for the top and sub cabinets plus an active crossover or audio processor. Of course you are not limited to this combination, you can experiment with other setups as much as you like!Speakon wiring is made as follows: POSITIVE = +1 and +2 NEGATIVE = -1 and +1 Cables to be used: You can use readymade cables but of course you can also assemble the speaker cables yourself. Take care ® to use good quality speaker cable with at least 2x 2. You will also need a pair of Neutrik ® Speakon NL4FC connectors. [. . . ] Clean the cabinet with a sponge and some non aggressive soap solution. Don't use any chemical solvents as they attack the enclosure!Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE JBSYSTEMS LIGHT RS-218B
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual JBSYSTEMS LIGHT RS-218B will begin.
