User manual JBSYSTEMS LIGHT SCARAB LASER V 1.0

[. . . ] ⷠLocate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. The fixture must be fixed at least 50cm from surrounding walls. ⷠDon't cover any ventilation openings as this may result in overheating. ⷠPrevent use in dusty environments and clean the unit regularly. [. . . ] If you sell the fixture, be sure to add this user manual. According to the EN 60825-1:1994 + A1:2002 + A2:2002 regulations, this laser falls under the classification 3R. Laser radiation can cause eye damage and/or skin damage. All protective measures for a safe operation of this laser must be applied. LASER OUTPUT: On the front of the enclosure there's a large opening where the laser beam leaves the enclosure, make sure to NEVER look inside the unit through this opening while the laser effect is switched on!HANGING BRACKET: with 2 screws on both sides to fasten the unit and a mounting hole to fix a mounting hook. This product is a so-called show laser, emitting radiation with a wavelength spectrum between 400 and 700 nm and producing lighting effects for shows. ⷠDue to the construction of this laser, the beam is moved so fast, that it can only hit the eye very short. This is why the use of this laser for a Laser-Light-Show can be regarded as save. ⷠNever direct the laser beam to people or animals and never leave this device running unattended. ⷠThis laser may only be used for shows. The operation of a class 3R show laser is only allowed if the operation is controlled by a skilled and well-trained operator. ⷠDepending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from country to country. The user must always inform himself on the legal instructions valid in his country and apply them to his situation. Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect installations and unskilled operation!DC 9V INPUT: this input is used to connect the AC/DC adapter. ON/OFF SWITCH: used to switch the unit on/off. Make sure you have fully read and understood all safety related issues in this user manual before you switch on the laser!AUDIO SENSITIVITY: when the laser is set to audio mode you can adapt the sensitivity of the built-in microphone to obtain optimal performance. MODE SWITCH: used to set the unit in one of the 3 available modes. PATTERN SELECTOR: when the unit is used in manual pattern mode, you can select the preprogrammed patterns by pressing this button. [. . . ] Power input: AC/DC power adapter: Sound Control: Laser Power: Laser radiation class: Laser Safety Standard: Size: Weight: 9Vdc (>800mA) AC 230V, 50Hz 9Vdc (800mA or more) Internal microphone 4. Every information is subject to change without prior notice Make sure the area below the installation place is free from unwanted persons during servicing. ⷠSwitch off the unit, unplug the mains cable and wait until the unit has been cooled down. During inspection the following points should be checked: · All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. [. . . ]